Home > Carrier > Thermostat > Carrier Tbpac01a Manual

Carrier Tbpac01a Manual

Here you can view all the pages of manual Carrier Tbpac01a Manual. The Carrier manuals for Thermostat are available online for free. You can easily download all the documents as PDF.

Page 1

T B --- P A C 0 1 --- A
T B --- P H P 0 1 --- A
Base Series Programmable Thermostats
Installation Instructions
Designed and Assembled
in the USA.
US patents: US20060165149 A1, USD578026 SI, US6205041 B1
A07107
Base Series Programmable Thermostat
NOTE: Read the entire instruction manual before starting the
installation
TABLE OF CONTENTS
PAGE
SAFETY CONSIDERATIONS 1.........................
INTRODUCTION 1...................................
INSTALLATION CONSIDERATIONS 1...................
INSTALLATION...

Page 2

2 thermostat is operated from batteries. The thermostat will continue
to operate if J2 is not in the correct position or not connected.
However, the backlight will not operate.
INSTALLATION
IMPORTANT: Install batteries last to ensure proper thermostat
mounting and latch engagement.
Step 1 — Thermostat Location
Thermostat should be mounted:
SApproximately 5 ft (1.5m) from floor.
SClose to or in a frequently used room, preferably on an inside
partitioning wall.
SOn a section of wall without pipes or duct...

Page 3

3 14. Turn ON power to unit.
On power up, depending on the thermostat model being used, the
LCD readout will display either AC for air conditioner model
(1--stage heat/1--stage cool) or HP for heat pump model (2--stage
heat/1-- stage cool).
Step 3 — Set Thermostat Configuration
Configuration options enable the installer to configure the
thermostat for a particular installation.
These are not presented to the homeowner and therefore must be
properly set by the installer. Following is a list of the...

Page 4

4 pressing UP and FAN buttons simultaneously or changing the
setpoint will override the timer for 1 cycle.
Minimum on Timer
Once the equipment has turned on, it will remain on for a
minimum of 3 minutes regardless of demand. However, the
equipment can turn off in less than 3 minutes if a change in
setpoint, or a change in mode occurs.
Staging Timer
If the thermostat is a heat pump model, it has 2--stage heat
capability. In normal operation there is a 15-- minute delay between
the first and second stages...

Page 5

T B --- P A C 0 1 --- A
T B --- P H P 0 1 --- A
Base Series Programmable Thermostats
Homeowner’s Guide
Designed and Assembled
in the USA.
A07107
Base Series Programmable Thermostat
SETTING TIME AND DAY
At Power Up
When power is first applied, AC or HP will appear for 5 seconds to
tell you it is an air conditioner (AC) or a heat pump (HP) model.
After this, the time display will flash to tell you the power has been
off.
Setting The Current Time:
1. Press the TIME/TEMP button. SET TIME flashes on the...

Page 6

2
Programming A Weekly Comfort Schedule:
1. Press the PROGRAM button. The word PROGRAMMING
appears on the display and the words SET TIME flash on
the display. MoTuWeThFr or SaSu and the morning period
icons will appear on the display. The current mode (HEAT
or COOL) will also show. Use the DAY button to select
weekdays and the PROGRAM button to select MORNING.
2. Press the UP or DOWN button to set the start time for
MORNING ( 1) value in Table 1).
3. Press the TIME/TEMP button until COOL is on and SET...
Start reading Carrier Tbpac01a Manual

Related Manuals for Carrier Tbpac01a Manual

All Carrier manuals