Toshiba Memory Installation Guide Manual

							The Toshiba PortŽgŽ 300CTcomes standard with 32MB of memory sol-
dered.  It can be expanded to a maximum of 64MB by installing the fol-
lowing Viking Components memory options into its one available expan-
sion slot. 
The Toshiba PortŽgŽ 310CTand 320CTcome standard with 32MB of
memory soldered.  They can be expanded to a maximum of 96MB by
installing the following Viking Components memory options into their
one available expansion slot. 
Description Viking P/N
16MB Memory Module T30016, RT30016
32MB Memory Module T30032, RT30032
64MB Memory Module T30064, RT30064
Caution:
Electro Static Discharge (ESD) can damage electronic components.  Before
touching the memory module, ensure that you are discharged of static elec-
tricity by touching a grounded metal object.
INSTALLATION INSTRUCTIONS:
1. Turn the computer off and disconnect the AC power supply and any
other cables from the unit.
Note: If the unit appears to be powered down, ensure that it is not in
Suspend mode.
2. Turn the computer upside-down.  Remove the battery from the system.
If a second battery is installed, remove it as well.  If you are not familiar
with this procedure, please refer to your computerÕs Ò
OwnerÕs Manual.Ó
3. Locate the memory expansion
cover on the bottom panel.
Locate the two holding screws
securing the cover to the bottom
panel.  Remove the screws with a
small Phillips-Head screwdriver.
Then remove cover by lifting up.  4. Locate the memory expan-
sion slot in the open compart-
ment.  Notice the location of
the off-center key on the
expansion slot. 
5. To install a memory module, insert the module into the expansion slot
at an angle and then push it down until it clicks into place.  To be certain
that the module is installed correctly, ensure that the off-center notch on
the module is aligned with the off-center key of the expansion slot.  The
module can only be installed one way due to the position of the notch.
6. Replace the expansion cover and be sure to secure its two holding
screws.  
7. Replace the battery back into its compartment and turn the system
right-side up.  
8. Replace the AC power supply and any other cables you may have dis-
connected.  
9. Open the display screen and turn the system on.  The computer will
automatically reconfigure itself to recognize the newly added memory.
The new memory can be verified during the POST routine at start-up and
at the SETUP utility. 
The installation is now complete. 
WARRANTY & DISCLAIMERS:
All Viking Components products have been thoroughly tested free of defects in
material and workmanship.  If any malfunction should occur while using one of
our products in its recommended environment, Viking, at its option, will repair or
replace the product at no charge, provided the product or any part thereof has not
been abused, misused, neglected, replaced, repaired or modified.  Viking shall
make the final determination as to the existence and the cause of any defect.
Viking will not repair or replace products designated as having a ÒLimited
LifetimeÓ which fail solely because their estimated life has expired.  No warranty
is made with respect to customer products produced to original purchaser specifi-
cations except as specifically stated in writing by Viking.  
All shipping costs shall be the responsibility of the purchaser.
Except as provided herein, there are no express or implied warranties of mer-
chantability or fitness for a particular purpose.  Under no circumstances will
Viking Components be liable in any way to the purchaser for any damages, includ-
ing but not limited to lost revenue, lost wages, or any other incidental or conse-
quential damages arising out of the use of or inability to use this product.  Viking
reserves the right to make modifications in both hardware and software without
prior notifications.  
All Viking Components are 100% guaranteed compatible with the OEM machines
for which they are designed.  All OEMs names, trademarks and part numbers are
used for identification purposes only, and in no way imply that any of our products
are original equipment parts.
Toshiba and PortŽgŽ are registered trademarks of Toshiba Corporation. 
SPEED  POWER  PERFORMANCE
Viking Memory
INSTALLATION GUIDE
Manual No. 1005207  ¥  Release 07/98, Rev. B
TOSHIBA¨
PortŽgŽ 300CT, 310CT, 320CT
Copyright 1998 Viking Components, Inc.