Tascam Dvd Player DV-D01U Owners Manual

							
TASCAM  DV-D01UT/C  1

Maintenance
Handling Discs
Remove the disc from its case by holding 
it at the edge while pressing the center hole 
lightly.
Do not touch the shiny surface of the disc 
or bend the disc.
Put the disc back in its case after use to 
prevent warping.
Be careful not to scratch the surface of the 
disc when placing it back in its case. 
Avoid exposure to direct sunlight, extreme 
temperature and moisture.
·
•
•
•
•
•
To clean the disc 
Wipe the disc with a soft cloth in a straight 
line from center to edge.
DO NOT use any solvent — such as 
conventional record cleaner, spray, 
thinner or benzine — to clean the disc.
Cleaning the unit
Stains on the unit should be wiped off with a soft cloth. If the 
unit is heavily stained, wipe it with a cloth soaked in water-
diluted neutral detergent and wrung well, then wipe clean with 
a dry cloth.
Since the unit may deteriorate in quality, become damaged or 
get its paint peeled off, be careful about the following.
DO NOT wipe it with a hard cloth.
DO NOT wipe it forcefully.
DO NOT wipe it with thinner or benzine.
DO NOT apply any volatile substance such as insecticides 
to it.
DO NOT allow any rubber or plastic to remain in contact 
with it for a long time.
•
·
•
•
–
–
–
–
–
Troubleshooting
PROBLEMPOSSIBLE CAUSESOLUTION
Power does not come on.The power cord is not connected.Connect the power cord correctly. (See page 8.)
The remote control does not 
work.
The batteries are exhausted.Replace the batteries. (See page 6.)
Sunlight is shining directly on the remote sensor.Hide the remote sensor from direct sunlight.
The disc reading time is 
too long.
The disc is dirty.Clean the disc by referring to “Maintenance” above.
No sound.The audio cable is not connected.Check the connection. 
No sound is produced 
when playing back a 
DVD recorded with high 
sampling (88.2 kHz or 
more) linear PCM audio 
using the DIGITAL OUT 
(OPTICAL) jack.
The audio signal is not derived from the unit’s 
DIGITAL OUT (OPTICAL) jack.
Use analog AUDIO OUT when playing back such 
discs.
No picture is displayed on 
the TV screen.
The video cable is not connected correctly.Connect the cable correctly. (See page 7.)
The disc or file is not playable.Use a playable disc or file. (See pages 3 and 4.)
No picture is displayed on 
the TV screen, the picture 
is blurred, or the picture is 
divided into two parts.
The scan mode is set to “480p”(NTSC) or 
“576p”(PAL) though the unit is connected to the 
TV which does not support the progressive video 
input such as a conventional TV.
Change the scan mode to “480i” (NTSC) or “576i” 
(PAL) though. (See page 10.)
Video and audio are 
distorted.
The disc is scratched or dirty.Replace or clean the disc.
A VCR is connected between the unit and the TV.Connect the unit and TV directly. (See page 7.)
The picture does not fit the 
TV screen.
The monitor type is not set correctly.Set “MONITOR TYPE” properly. (See page 26.)
No picture is displayed on 
the TV or no sound come 
out through HDMI connec-
tion.
A video or audio format not compatible with this 
unit and/or TV is played.
Check the video or audio format of the signal to see 
if it is compatible with this unit and/or TV.
A HDCP-compatible TV is not connected.Connect a HDCP-compatible TV. (See page 7.)
The unit failed to recognize the TV connected with 
the HDMI cable.
Disconnect the HDMI cable and connect it again.
A HDMI cable longer than 5 m (15 ft) is used.Use a HDMI cable shorter than 5 m (15 ft) to assure 
stable operation and picture quality.
The picture is distorted 
when the TV is connected 
through HDMI terminal.
Proportion of the picture may not be shown 
correctly depending on a disc/file when the TV is 
connected through HDMI terminal.
Connect the TV through component video, S-video, 
or composite video jacks (see page 7), then set the 
scan mode to “480p” (see page 10).
If there are any other cases than the noted above or if this unit does not seem to work properly, turn off the unit and turn it back on.
References 
						

							
 TASCAM  DV-D01UT/C

Specifications
General
Power Requirements: U.S.A./Canada 120 VAC, 60 Hz 
U.K./Europe  230 VAC, 50 Hz
 
Australia  240 VAC, 50 Hz
 
Asia  100-240 VAC,
 
  50-60Hz
Power Consumption:  at operation 11 W
  in standby mode
 
  U.S.A./Canada/Asia  0.2 W
 
  U.K./Europe  0.6W
Dimensions (W x H x D):  482 mm x 51 mm x 269 mm
  (19 inches x 2 inches x 10.6 
inches)
Mass:  2.6 kg (5.8 lbs)
Audio section
Analog output:
AUDIO OUT:  –8 dB/1 k
Ø
Digital output*1:
DIGITAL OUT (OPTICAL):    –21 dBm to –15 dBm
  (660 nm 
±30 nm)*1 Corresponding to Linear PCM, Dolby Digital, and DTS Digital 
Surround (with sampling frequency — 32 kHz, 44.1 kHz, 48 kHz)
Video section
Video System: NTSC
Horizontal Resolution:  500 lines
Signal-to-Noise Ratio:  64 dB
Video output level
Composite:  1.0 V(p-p)/75 
Ø
S-video-Y:   1.0 V(p-p)/75 
Ø
S-video-C:   0.286 V(p-p)/75 
Ø
References
STOPOPEN/CLOSEPLAY
43523.523.5
(269)
482
7
44(EIA1U)
1.6
Dimensions (unit: mm)
Component-Y:   1.0 V(p-p)/75 Ø
Component-PB/PR:    0.7 V(p-p)/75 Ø
HDMI
HDMI Output (Ver. 1.0):  HDMI
RS-232C
Serial command:  9-Pin D-SUB
Designs & specifications are subject to change without notice.
HDMI, the HDMI logo and High-Definition Multimedia 
Interface are trademarks or registered trademarks of HDMI 
Licensing LLC.
HDCP is the abbreviation of “High-Bandwidth Digital Content 
Protection,” and is the high-reliable copy control technology 
licensed by Digital Content Protection, LLC.
•
•                                                                                                           
						

							
TASCAM  DV-D01UT/C 
Notes 
						

							
TEAC CORPORATION
Phone: +81-422-52-5082 www.tascam.com
3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan
 TEAC AMERICA, INC.
Phone: +1-323-726-0303 www.tascam.com7733 Telegraph Road, Montebello, California 90640
 TEAC CANADA LTD.
Phone: +1905-890-8008  Facsimile: +1905-890-9888 www.tascam.com5939 Wallace Street, Mississauga, Ontario L4Z 1Z8, Canada
 TEAC MEXICO, S.A. De C.V
Phone: +52-555-581-5500 www.tascam.comCampesinos No. 184, Colonia Granjes Esmeralda, Delegacion Iztapalapa CP 09810, Mexico DF
 TEAC UK LIMITED
Phone: +44-8451-302511 www.tascam.co.ukUnit 19 & 20, The Courtyards Hatters Lane, Watford, Hertfordshire. WD18 8TE, U.K.
 TEAC EUROPE GmbH
Phone: +49-611-71580  www.tascam.deBahnstrasse 12, 65205 Wiesbaden-Erbenheim, Germany
Printed in Malaysia 
»
DV-D01U