Home > Tascam > Cassette Player > Tascam DA 88_quick Start Guide

Tascam DA 88_quick Start Guide

Add to Favourites
    Download as PDF

    View the Tascam DA 88_quick Start Guide for free. All the Tascam manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 1 DA-88 QUICK TIPS (VERSION 4 SOFTWARE) ABS / TC DISPLAY MODE SWITCHING (REQUIRES SY-88) 1) Hold DISPLAY and press UP to enter ABS display 2) Hold DISPLAY and press DOWN to enter TC mode ABS / TC REFERENCE SWITCHING (REQUIRES SY-88) 1) Default is ABS Time 2) With DISPLAY set to ABS, press both UP and DOWN, then press either UP or DOWN to toggle between ABS and TC 3) Press DISPLAY to exit AUTO PLAY FUNCTION 1) After either MEMO 1 or MEMO 2 have been captured 2) Enable AUTO PLAY 3) Press either LOC 1 or...
    Page 2 2 BEGINNING OF TAPE PLAY 1) Hold REW, FF and PLAY while powering On BEGINNING OF TAPE STOP 1) Hold FF and PLAY while powering On CHASE LOCK SYNCHRONIZATION (CODE ONLY MASTER) (Requires SY-88) [Dip-switch settings] 1) In a post environment, all dip-switches would typically be set to the DOWN position, unless the VIDEO THRU jack is used, in which case dip-switch S1 #1 would be UP. 2) If a composer is running virtual MIDI tracks in sync with the DA-88 while slaved to TC, place dip-switch S1 #2 in the...
    Page 3 3 350 to 400 hours: Perform manual cleaning of heads and guides. Check tape path alignment after cleaning. (requires proper test and measurement equipment, and should be performed by qualified service personnel) During third cleaning, (1000 hours) a complete alignment check is suggested. Remember, the duration between cleanings may vary depending on your environment. A dusty or smokey environment will shorten the cleaning cycle. Although most name brand tapes are of very high quality, it is possible...
    Page 4 4 Note: Make certain that the Master tape is write protected. 6) Engage all REC FUNCTION switches on the Target DA-88 so as to arm all tracks Note: If dubbing Time Code, engage the TC REC FUNCTION switch, but DO NOT start the generator. 7) On Target DA-88, engage CHASE so that it locates to the same time position as the Source DA-88 8) On Target DA-88, engage DIGITAL IN 9) On Source DA-88, hold RECORD and press PLAY END OF TAPE REWIND 1) Hold REW, STOP and PLAY while powering On END OF TAPE STOP 1)...
    Start reading Tascam DA 88_quick Start Guide

    Related Manuals for Tascam DA 88_quick Start Guide

    All Tascam manuals