Pocket Radio Sangean Dt220v Operating Instruction

DT-220V
Operating instruction
Instruccions de manejoGB
E 

1 

2 

3GB   Controls
    Telescopic Aerial                    Display
    Preset 6-10                            Display button
    Stereo/Mono/Alarm button
    Band/Time set button
    Power button                          Light button
    Tuning up/down button           Preset 1-5
    Lock switch                            Volume Control
    Loudspeaker/Headphone switch
    Headphone socket                DC input socket
    Auto wind earphones
    Auto wind earphones switch
    Battery compartment...

4  Installing batteries
1. position the radio face down.
2. Press the catch and slide in the direction of the
    arrow.
3. Lift up the battery cover.
4. Insert 2xUM-3 (AA) size batteries. Make sure the
    batteries are positioned in accordance with the
    diagram indicated.
5. Replace the battery cover.
  Battery replacement
The battery indicator       will appear and flash in the
display when the batteries are in need of replacement
. After removing the batteries, you have
approximately 3 minutes to...

5GB   Setting the alarm time
1. Ensure that the radio is switched off.
2. Press and hold down the Alarm button for more
    than 2 seconds until the hours digit and alarm
    symbol begin to flash in the display .
3. Whilst the hours digit is flashing, adjust the hours
    using the Tuning Up/Down buttons.
4. Press the Alarm button, the minute digit begins to
    flash in the display.
5. Whilst the minute digit is flashing, adjust the
    minutes using the Tuning Up/Down button.
6. Press the Alarm button...

6  Operating the radio-search tuning
1. Switch on your radio by pressing the Power Button.
Note: The radio is originally set to be 90 minutes auto
         shut off after Power is switched on (       symbol
          will appear on the display). If you don’t need
         this feature, press Power button for more than
         2 seconds until        symbol removed from the
         display .
2. Select the required waveband by repeatedly
    pressing the Band button. On FM and TV bands,
    fully extend...

7 DGB  Operating the radio – manual tuning
1. Switch on your radio by pressing the Power button.
2. Select the desired waveband using the Band
    button. The waveband selected will appear in the
    display. On FM/TV bands, fully extend the
    Telescopic aerial. On AM (MW) band, rotate
    your radio for best reception.
3. A single press on either the Tuning Up/Down will
   change the frequency up or down. Adjust the
   Volume control to the required level.
  AM(MW) tuning step
In Europe and other...

8  Presetting stations
You may store up to 10 stations each on FM, AM
(MW) and TV bands giving a total of 30 preset
stations.
1. Tune into the required stations using one of the
    tuning methods previously described .
2. To store the station, press and hold down one of
    the PRESET button 1-5 for more than 2 seconds
    until display shows preset location.
3. To store the station into preset 6-10, press +5
    button, display will show +5, then press and hold
    down one of the PRESET button 1-5 for...

9GB   Display backlight
Pressing the Light button will switch on the display
backlight and illuminate the display for approximately
7 seconds.
  Lock switch
The lock switch located on the right side of your radio
is used to prevent unintentional operation.
1. Slide the Lock switch to the up ‘ locked ‘ position,
    the       symbol will appear in the display. The
    Power and all other buttons will be disabled except
    the Light button . This will prevent accidental
    operation when the radio is...