Panasonic Network Camera Wv Sw458m Installation Guide

31
Using the mount bracket SW458
z Using the camera attachment position marker as a guide, attach the came\
ra onto the camera attachment (accessory) while aligning the “OPEN” mark of the cam\
era with the projection of the 
camera attachment (accessory). 
IMPORTANT: 
	•		When	 mounting	 the	 camera	 body,	 cables	 shall be run between the camera attach-
ment (accessory) and mount bracket as 
indicated by the arrows in the illustration.
 *   Cable running as indicated by the arrows in 
the illustration...

32
x  Engage the camera attachment fixing screws of the camera with the screw hole of the camera 
attachment (accessory) and rotate the camera 
in the direction of the arrow to secure the cam-
era to the camera attachment (accessory).
   Rotate the camera until a click is heard so that 
the projection of the camera attachment (acces-
sory) will be set to the “LOCK” position.
c Secure the camera with the camera fixing screw.
(Recommended tightening torque: 1.37 N·m 
{1.01 lbf·ft})
IMPORTANT:
	•		Ensure...

33
Cable guideCable guide
Connected cable
 b  Accommodate the connected cables inside the 
cable guide of the camera mount bracket.
IMPORTANT: 
	•		 To	 prevent	 the	 cables	 from	 being	 caught	
when the base cover (accessory) is 
attached, keep the cables inside the cable 
guide.
 
n  Attach the base cover (accessory) that was 
removed according the steps in page 20.
 
m  Use the bit for tamperproof screw (accessory) 
to tighten the fixing screws provided on both 
sides of the base cover (accessory)....

34
Configure the network settings
Configuring the camera so that it can be accessed from a PC
The	following	are	descriptions	for	when	the	camera	with	default	settings	is	configured.	If	you	
are 	using	firewall	software	on	your	PC,	the	Setup	Program	may	not	be	able	to	find	any	
cameras	on	your	network.	Configure	the	setting	of	the	camera	after	temporarily	invalidating	
the	firewall	software.	Contact	the	network	administrator	or	your	Internet	service	provider	for	
information	about	configuring	the	settings...

35
c  Select	the	camera	you	want	to	configure,	and	click	[Access	Camera].
Note: 
	•		 When	cameras	are 	displayed	in	[IP	Setting	Software]	screen,	click	the	camera	with	same 
MAC	address	as	the	MAC	address	printed	on	the	camera	that	you	want	to	configure.
v   If	the	installation	screen	of	the	viewer	software	“Network	Camera	View	4S”	is	displayed,	follow	
the	instructions	of	the	wizard	to	start	the	installation.	(The	viewer	software	is	installed	from	the	
camera.)
	 •	 The	“Live”	page	will	be	displayed....

36
Before asking for repairs, check the symptoms with the following table. 
Contact your dealer if a problem cannot be solved even after checking and trying the solution in th\
e 
table or a problem is not described below. 
SymptomCause/solutionReference 
pages
Power is not turned on.  When using DC power supply
	 •	 Is	12	V	DC	power	supply	connected	to	the	2P	
power supply cable?
  →  Check whether the connection is appro-
priately established.
	 •	 Is	 the	 AC	 adaptor	 in	 use	 compliant	 with	 the...

37
• Basic
Power source:12 V DC, PoE (IEEE802.3af compliant)
Power consumption:
12 V DC*: 540 mA/ 6.5 W
PoE 48 V: 125 mA/ 6.0 W (Class 2 devices)
*  ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY or  LIMITED POWER SOURCE.
Ambient operating temperature: -40 °C to +50 °C {-40 °F to 122 °F}
Ambient operating humidity: Less than 90 % (no condensation)
Waterproof: Main body: IP66 (IEC60529)
*  
Only when installation work specified in this book is properly 
performed and appropriate waterproof treatment is...

38
Scanning system:Progressive
Minimum illumination: Color: 
1.5 lx {0.15 footcandle} 
(F2.4, Auto slow shutter: Off (1/30 s), Gain: On(High)) 
0.1 lx {0.01 footcandle} 
(F2.4, Auto slow shutter: max. 16/30 s, Gain: On(High))*
BW:  1.2 lx {0.12 footcandle} 
(F2.4, Auto slow shutter: Off (1/30 s), Gain: On(High)) 
0.08 lx {0.008 footcandle} 
(F2.4, Auto slow shutter: max. 16/30 s, Gain: On(High))*
* Converted value
Super-Dynamic: On/Off
Dynamic range: 52 dB typ. (only at Super-Dynamic On)
Gain (AGC): On...

39
• Lens
Focal length:0.837 mm
Maximum aperture ratio: 1:2.4 (Fixed)
Angular field of view:
Horizontal: 182° Vertical: 176°
• Network
Network:
SW458   10BASE-T/100BASE-TX, RJ-45 connector (female)
SW458M   10BASE-T/100BASE-TX, M12 connector (male)
Resolution: 2M Panorama [16:9]/ 2M Double Panorama [16:9]:
H.264(1)
H.264(2)
JPEG1920x1080/640x360/320x180 max.30 fps
640x360/320x180 max.30 fps
1920x1080/640x360/320x180 max.30 fps
1M Panorama [16:9]/ 1M Double Panorama [16:9]:
H.264(1)
H.264(2)
JPEG...

40
Image compression method*1: JPEG (MJPEG)Image quality: 
  0 SUPER FINE/ 1 FINE/ 2/ 3/ 4/ 5 NORMAL/ 6/ 7/ 8/  
9 LOW (10 steps: 0-9)
Transmission type: PULL/PUSH
Transmission interval: 0.1 fps - 30 fps (JPEG frame rate will be restricted when dis-
playing both JPEG and H.264 images.)
Audio compression method: G.726 (ADPCM)            32 kbps/16 kbps G.711                 64 kbps
Bandwidth control: Unlimited/ 64 kbps/ 128 kbps/ 256 kbps/ 384 kbps/  
512 kbps/ 768 kbps/ 1024 kbps/ 2048 kbps/ 4096 kbps/...