Panasonic Kx Ta824 Installation Manual

1.3 Specifications
Installation Manual 21
Extension Group 8
Message Waiting 8 per extension
Message for Built-in Voice Message 125 messages (total 60 minutes)Item Max. Quantity 

1.3 Specifications
22 Installation Manual 

Installation Manual 23
Section 2
Installation
This section provides detailed instructions for installing the 
PBX, optional service cards, and peripheral equipment. 

2.1 Before Installing
24 Installation Manual
2.1 Before Installing
2.1.1 Before Installing
Please read the following notes concerning installation and connection before installing the PBX and 
terminal equipment. 
Be sure to comply with all applicable laws, regulations, and guidelines.
Safety Installation Instructions
When installing telephone wiring, basic safety precautions should always be followed to reduce the 
risk of fire, electric shock and injury to persons, including the following:
1.Never...

2.1 Before Installing
Installation Manual 25
4.Use 2-pair telephone cables when connecting Panasonic PTs.
Use 1-pair telephone cables when connecting single line telephones (SLTs), data terminals, 
answering machines, computers, voice processing systems, etc.
5.Unplug the PBX from its power source when wiring, and plug the PBX back in only after all wiring 
is completed.
6.Mis-wiring may cause the PBX to operate improperly. Refer to Section 2, Installation when 
wiring the PBX.
7.If an extension does not...

2.2 Installing the Advanced Hybrid System
26 Installation Manual
2.2 Installing the Advanced Hybrid System
2.2.1 Unpacking
The following items are included upon shipment.
Main Unit 1
AC Cord 1
CD-ROM, Documentation 1 set
Screw (Wall Mounting) 3
Washer (Wall Mounting) 3
Pager Connector 1
Audio Source Connector 1
Strap 1
Rivet 1 

2.2 Installing the Advanced Hybrid System
Installation Manual 27
2.2.2 Names and Locations
Side View
RS-232C Port
USB Port
AC Inlet
Protective Ground Terminal
Power Switch
Run Indicator Extension Modular JacksMOH Jack
Outside (CO) Line Modular JacksPager Jack
Strap Hole 

2.2 Installing the Advanced Hybrid System
28 Installation Manual
2.2.3 Opening/Closing Covers
Opening Covers
1.Loosen the top cover screw.
2.Remove the top front cover.
Note
The screw cannot be removed from the cover.
3.Remove the 2 bottom-cover screws.
4.Open the bottom front cover.
Top Front Cover
Screw
Screws
Bottom Front Cover 

2.2 Installing the Advanced Hybrid System
Installation Manual 29
Closing Covers
1.Replace the bottom front cover.
2.Attach the 2 bottom-cover screws.
3.Replace the top front cover and tighten the screw.
Note
For safety reasons, keep the front covers closed while the PBX is in operation.
Bottom Front Cover
Screws
Top Front Cover
Screw 

2.2 Installing the Advanced Hybrid System
30 Installation Manual
2.2.4 Securing Cords
1.Insert the rivet into the hole in the strap.
2.Insert the rivet and strap into the hole on the PBX.
3.Wrap the strap around all of the cords.
4.Close the covers. (→ 2.2.3 Opening/Closing Covers)
5.Tie together all of the connected cords and secure them to the wall so that they cannot be pulled 
out of the PBX.
Rivet