Nortel Modular Ics 6.1 Installer Guide

Private networking using PRI SL-1 / 161
P0603534  02Modular ICS 6.1 Installer Guide
Assigning PNIs
1. After you enter your password, press ‘ until the 
prompt displays System Prgrming: 
2. Press ≠. The prompt displays Hunt groups.
3. Press ‘ until the prompt displays Dialing Plan.
4. Press ≠. The prompt displays Private Network.
5. Press ≠. The prompt displays Type.
6. Press CHANGE
 to until you reach CDP. 
7. Press ‘. The prompt displays PrivNetID.
8. Enter the private network ID for your system....

162 / Private networking using PRI SL-1
Modular ICS 6.1 Installer GuideP0603534  02
12. Repeat these steps for all the modes that are directly 
adjacent to your system.
Local system
To set up the local system, you need to assign a target line to 
the DN for the voice mail system, then enter that DN into the 
target line record.
1. After you enter your password, at the Terminals&Sets 
prompt, press ≠.
The prompt displays: Show set: 
2. Enter the DN number for the Auto Attendant.
3. Press ≠. The prompt...

Private networking using PRI SL-1 / 163
P0603534  02Modular ICS 6.1 Installer Guide
Remote system
On the nodes that are not directly connected to the central Auto 
Attendant system, you need to use the Telco Features 
headings to identify the route to the system.
1. After you enter your password, press ‘ until the 
prompt displays Telco Features: 
2. Press ≠. The prompt displays VMsg Center 
tel#s.
3. Press ≠. The prompt displays VMsg Center 1.
4. Press ≠. The prompt displays Use:.
5. Press CHANGE
 to...

164 / Private networking using PRI SL-1
Modular ICS 6.1 Installer GuideP0603534  02
9. Press ≠. The prompt displays Caller ID Set.
10. Press ‘ until the prompt displays Extl VMsg 
set.
11. Press CHANGE
 to select Y (yes). 
Set Telco features for the target line
1. Press – until you reach the top level, then press 
‘ until the prompt displays Lines.
2. Press ≠. The prompt displays: Show line: 
3. Enter the target line number for the voice mail system.
4. Press ≠. The prompt displays: Trunk/line 
data: 
5....

Private networking using PRI SL-1 / 165
P0603534  02Modular ICS 6.1 Installer Guide
• From the CVM/CAA lines, use the default greeting table 1.
For detailed directions, refer to the addendum titled: Installing 
Norstar Voice Mail as a Centralized Voice Mail System. 

166 / Customer Use
Modular ICS 6.1 Installer GuideP0603534  02
Customer Use
This section shows sample configurations for different types 
of network access. Each example has four parts:
• A scenario explains the goal of the call and what is 
required to achieve it.
• A diagram shows the network configuration that supports 
the application.
• A list shows the Norstar hardware required to support the 
configuration.
• Tables show the programming. Only those settings that are 
important to network access...

Customer Use / 167
P0603534  02Modular ICS 6.1 Installer Guide
Call Norstar and select tie lines to a private network
A manager in Georgia wants to use the tie lines at headquarters 
to call Washington. He dials a telephone number that maps 
onto the DISA DN, enters a Class of Service (COS) password, 
then dials a line pool access code to select a tie line to 
Washington. 
Using tie lines
Ta r g e t  l i n e
203
Ms. Nelson
DIDAccountant
(225)
Accountant
(226)
Central OfficeDID trunk 
cartridges
Manager...

168 / Customer Use
Modular ICS 6.1 Installer GuideP0603534  02
Hardware: ICS, a Trunk Module with a DID Trunk Cartridge, 
two E&M/DISA Trunk Cartridges for the three trunks in the 
line pool to Washington, or a DTI with one DID line and three 
E&M lines. 
Incoming trunk:
Trk/Line Data
Line 049DID
Access codesDISA DN5321
Recd # lengthRecd # lengthfour digits (three to seven digits, 
but must match number of digits 
sent by central office)
Outgoing trunk:
Trk/Line Data
Line 053
Line typeE&M
Pool F
Access...

Customer Use / 169
P0603534  02Modular ICS 6.1 Installer Guide
Call Norstar and select lines to the public network
Gord wants to make a long-distance business call from home. 
To avoid being charged, he dials the telephone number that 
maps onto the Auto DN at work. After hearing the dial tone, 
Gord dials a line pool access code to select a line to the public 
network. He then dials the long-distance number. 
Using DID to dial long-distance
Hardware: ICS, a Trunk Module with a DID Trunk Cartridge 
or...

170 / Customer Use
Modular ICS 6.1 Installer GuideP0603534  02
Private network
All the calls described in this section originate from within the 
networked system.
Call one or more Norstar telephones
The production supervisor in Houston selects the less-
expensive company Tie line to call the manager at the 
Administration office in Dallas. Once the line is selected, the 
production supervisor dials the digits that will map onto the 
target line of the manager in Dallas.
Calling from a Norstar to a...