Home > NEC > Communications System > NEC Neax 2400 Ipx Isdn Feature Programming Manual

NEC Neax 2400 Ipx Isdn Feature Programming Manual

Here you can view all the pages of manual NEC Neax 2400 Ipx Isdn Feature Programming Manual. The NEC manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 41

NDA-24305 CHAPTER 4
Page 23
Revision 1.0
COMMANDS CONCERNING ISDN DATA ASSIGNMENT
IRL (CDN15)  Clear call when DTI alarm is detected.
0 = –
1  = Clear call when DTI alarm is detectedNote 2
Note 2:This data should be set when there is no Dch in the physical DTI.
MTC (CDN16)  Assignment of Timer T309 Value. Restoration timer (TC×MTC) sec.
0-15 = TC (CDN18) × MTC (Restart timer value)
TC (CDN17) Timer T309 Counter Value
0 =  – 4 = 30sec.
1 = 64 msec.5 =  5 min.
2= –6 =  1 sec.
3= 2 sec.7 =  –
DVRST (CDN20)...

Page 42

CHAPTER 4 NDA-24305
Pag e 2 4
Revision 1.0
COMMANDS CONCERNING ISDN DATA ASSIGNMENT
ANI (CDN31)  Timing to demand ANI Information
0  = There is no ANI demand at Incoming call
1 = After receiving 1st digit
2 = After receiving 2nd digit
3 = After receiving 3rd digit
4 = After receiving 4th digit
5 = After receiving 5th digit
6 = After receiving 6th digit
7 = After receiving 7th digit
SRV (CDN32) Additional Service SelectionNote 7
Bit0: Advice of Charge (AOC)
0 = Valid
1 = Invalid
Bit1: Malicious Call Trace...

Page 43

NDA-24305 CHAPTER 4
Page 25
Revision 1.0
COMMANDS CONCERNING ISDN DATA ASSIGNMENT
L/T (CDN35) Local/Toll  Note 10 
0 = Local
1=Toll
Note 10:Only for Russia
ECCIS (CDN36) Event Based CCIS (E-CCIS) for the public ISDN Line
0/1 = Out of Service/In Service
ECCISTM (CDN37)  Release timer for E-CCIS Line
0 = 3 minutes (Default setting)
1 = 15 seconds
2 = 30 seconds
3 = 1 minute
4 = 2 minutes
5 = 5 minutes
6 = 10 minutes
7 = 15 minutes
8 = 30 minutes
9 = 1 hour
10-13 = Not used
14 = Immediately after call...

Page 44

CHAPTER 4 NDA-24305
Pag e 2 6
Revision 1.0
COMMANDS CONCERNING ISDN DATA ASSIGNMENT
JECCIS (CDN48) Common Use with E-CCIS RT  Note 11
0/1 = Out of Service/In Service
ECCIS2 (CDN49) E-CCIS System  Note 11
0 = Fixed Channel System
1 = Common Channel System
2=Not used
3=Not used
Note 11:Valid since Series 7300 Release 4.
CTCF (CDN52) SS-CT/SS-CF Service  Note 12
0/1 = Out of Service/In Service
Note 12:Valid since Series 7400 Release 8.
RERT (CDN53) Rerouting function (used in conjunction with SS-CT/SS-CF...

Page 45

NDA-24305 CHAPTER 5
Page 27
Revision 1.0
CHAPTER 5 GATEWAY SERVICE
This chapter explains data assignment for ISDN gateway service. Refer to ISDN Features and Specifications for
availability of each Gateway Service on the Fusion Network.
Table 5-1  Gateway Service List (1/4)
SERVICE
FEATURE
CODESERVICE FEATURE NAME REMARKS
A-76Alternate Routing-PRI
A-88Automatic Call Distribution-PRI
A-92Announcement Service-PRI
A-94Automatic Circuit Assurance-PRI
A-96Automatic Trunk Test-PRI
B-19Boss-Secretary...

Page 46

CHAPTER 5 NDA-24305
Pag e 2 8
Revision 1.0
GATEWAY SERVICE
D-116DDo Not Disturb-Dterm-PRI
D-117Data Line Security-PRI
D-118Data Privacy on Demand-PRI
D-119Data Interface-Automatic Answer-PRI
D-120Data Transparency-PRI
D-121Data Communications-PRI
D-122Data Uniform Numbering Plan-PRI
D-137Direct-In Termination (DIT)-PRI
E-14DElapsed Time Display-D
term-PRI
F-21Flexible Numbering of Stations-PRI
F-26Faulty Trunk Report-PRI
H-14DHands-Free Answer Back-D
term-PRI
H-15Hot Line-Outside-PRI
I-24Incoming Call...

Page 47

NDA-24305 CHAPTER 5
Page 29
Revision 1.0
GATEWAY SERVICE
L-46LDN Night Connection-Outside-PRI
L-49LCR-Special Line Warning Tone-PRI
M-71Miscellaneous Trunk Access-PRI
M-72Miscellaneous Trunk Restriction-PRI
M-73Music On Hold-PRI
M-74Modem Pooling-PRI
M-75Multiple Call Forwarding-All Calls-PRI
N-20Night Connection-Fixed-PRI
N-21Night Connection-Flexible-PRI
N-22Non-Delay Operation-PRI
N-29Night Connection Outside-System-PRI
N-31Nailed Down Connection-PRI
O-24Outgoing Trunk Queuing-PRI
O-26Outgoing Trunk...

Page 48

CHAPTER 5 NDA-24305
Pag e 3 0
Revision 1.0
GATEWAY SERVICE
S-84Speed Calling-Station-PRI
S-85Speed Calling-Group-PRI
S-86Simultaneous Voice and Data Transmission-PRI
S-87Synchronous Data Switching-PRI
S-88SMDR for Data Call-RS232C-PRI
S-89Speed Calling Override-System-PRI
S-107Station Individual Trunk Access-PRI
T- 3 7Tandem Switching of Tie Trunk-2/4-Wire-PRI
T- 3 8Three-Way Calling-PRI
T-38DThree-Way Calling-D
term-PRI
T- 4 0Toll Denial/Toll Diversion-PRI
T- 4 1Toll Restriction-3/6-Digit-PRI
U-6Uniform...

Page 49

NDA-24305 CHAPTER 5
Page 31
Revision 1.0
ALTERNATE ROUTING-PRI
A-76 ALTERNATE ROUTING-PRI
1. General Description
This feature is provided with LCR which automatically routes ISDN outgoing on-net calls over alternate
facilities when the first-choice trunk group is busy. The user selects the first-choice route by dialing the
corresponding access code, and the equipment then routes the call through alternate trunk groups only if the first
is busy. The PBX will also add or delete digits, when necessary, to...

Page 50

CHAPTER 5 NDA-24305
Pag e 3 2
Revision 1.0
AUTOMATIC CALL DISTRIBUTION-PRI
A-88 AUTOMATIC CALL DISTRIBUTION-PRI
1. General Description
This feature allows Automatic Call Distribution (ACD) features to be activated for incoming calls from ISDN
trunks.
Table 5-1  ACD Features
CODE NO. FEATURE NAME AVAILABILITY
A-31 Abandoned Call Search ×
A-34 Assistance-ACD Agent×
A-35 Automatic Answer×
A-37 Availability-ACD Position×
A-80 Announcements×
B-21 Break Mode Not Applicable
C-35 Call Distribution to Agents×...
Start reading NEC Neax 2400 Ipx Isdn Feature Programming Manual

Related Manuals for NEC Neax 2400 Ipx Isdn Feature Programming Manual

All NEC manuals