Home > Namco > Games > Namco Motorcross Go Amendment Ins For Replacements Instruction Manual

Namco Motorcross Go Amendment Ins For Replacements Instruction Manual

Add to Favourites
    Download as PDF

    View the Namco Motorcross Go Amendment Ins For Replacements Instruction Manual for free. All the Namco manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 MOTOCROSS GO!™ Instructions for replacing the Steering Drive Gears and Drive Belt
    Page 2 Removing the Handle Bar Assembly 1. Remove 5off Security screws (M5x12) and remove the Steering Cover Vac-Form. 2. Disconnect the handlebar connector. 3. Remove 2off Pozi head screw (M5x10) and remove the Cable Joint Plate. 4. Remove the Pozi head screw (M4x12) to disconnect the Earth Tag. 5. Remove 8off Socket cap screws (M8x20) and remove the left and right support brackets. 6. Lift the Handle Bar assembly from the bike moulding only sufficient to disconnect the motor connector, then remove the Handle...
    Page 3 Replacing the Gears and Drive Belt 1. Disconnect the potentiometer connector. 2. Remove the grub screw (M4x10) and remove the potentiometer, complete with bracket. (Take care not to loose the grub screw which is reqired to refit the potentiometer.) 3. Slacken the 4off Hex head screws (M6x16), securing the motor mounting plate. 4. Slacken the Lock Nuts (M6) and Adjustment Screw (M6x50), to remove the tension from the Drive Belt, and remove the Drive Belt. 5. Loosen the grub screw (M4x10) on the Large...
    Page 4 9. Fit the spacer (supplied) to the motor shaft, and fit the new Small Gear. Note: When fitting the small gear ensure that one of the two retaing grub screws engage on the flat of the motor shaft.) 10. Refit the new Drive Belt. 11. Adjust the tension of the new drive belt with the adjuster screw (M6x50). When the tension is correct, re-tighten the two lock nuts (M6) Note: When refitting the Drive Belt adjust the Adjuster screw (M6x50) to obtain a belt tension of 7.5~9.5kgf. When tensioned correctly a...
    Start reading Namco Motorcross Go Amendment Ins For Replacements Instruction Manual

    Related Manuals for Namco Motorcross Go Amendment Ins For Replacements Instruction Manual

    All Namco manuals