Miele W 1714 User Manual

							Cleaning the siphon and conditioner
channel
1. Remove the siphon from
compartmentand rinse under
warm running water. Clean the
siphon tube in the same way.
2. Replace the siphon.

Clean the fabric conditioner channel
using a brush and warm water.
If starching frequently, thoroughly
clean the siphon, the siphon tube
and the fabric conditioner channel
regularly. A build-up of starch will
cause them to get clogged.Cleaning the detergent dispenser
drawer housing
Use a bottle brush to remove
detergent residues and limescale
from the jets inside the detergent
dispenser drawer housing.
Cleaning and care
31 
						

							Cleaning the water inlet filters
The washing machine has two filters to
protect the inlet valves.
These filters should be checked every
six months or so, or more often if there
are frequent interruptions to the water
supply.
To clean the filter in the union in the
open end of the inlet hose:
First turn off the stopcock.
Unscrew the threaded union
connecting the free end of the inlet
hose to the stopcock.

Remove rubber seal1from the
recess.

Using pointed pliers, take hold of
plastic filter bar2, remove the filter
and clean it.

Put the filter and seal back in the
reverse order and reconnect the
hose.

Turn on the stopcock and check the
connection is watertight. If it leaks,
tighten the connection.To clean the filter in the water inlet
valve:
Using pliers, carefully loosen the
ribbed plastic nut on the inlet valve
and unscrew.
Use pointed nose pliers to withdraw
the plastic filter by the bar (see
illustration). Clean, put back and
secure.
The two filtersmustbe put back in
place after cleaning.
Cleaning and care
32 
						

							With the help of the following notes, minor faults in the performance of the
machine, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
Repair work to electrical appliances should only be carried out by a
suitably qualified person in strict accordance with current local and national
safety regulations. Repairs and other work by unqualified persons could be
dangerous. The manufacturer cannot be held liable for unauthorised work.
The programme does not start
Problem Possible cause Remedy
The display remains
dark, and theStart/
Stopbutton indicator
light does not come
on.There is no power to
the machine.Check whether
– the mains plug is plugged
in and switched on.
– the fuse or circuit breaker
has tripped.
You are asked to enter
a code.Access via a code has
been activated.Enter the code and confirm
the entry. Deactivate the code
if you do not wish this
message to appear in the
display the next time the
machine is switched on.
The display is dark.The display has
switched off
automatically to save
energy (Standby
mode).Press a button. Standby
comes to an end.
Problem solving guide
33 
						

							Fault messages in the display
Problem Possible cause Remedy
lights up in the
display and
Drain fault
flashes.–The water outlet is
blocked or
restricted.
–The drain hose has
been fixed too high.–Clean the drain filter and
the drain pump.
–The maximum delivery
head is 1 m.
lights up in the
display and
Water inlet
fault
flashes.–The water inlet is
blocked or
restricted.Check whether
–the stopcock is opened
properly.
–the inlet hose is kinked.
– the water pressure is too
low.
lights up in the
display and
Waterproof
fault
flashes.The water protection
system has reacted.Call the Service Department.
lights up in the
display and
Technical
fault
flashes.There is a fault. Start the programme again.
If the fault message appears
again, contact the Service
Department.
Anti-crease
Chk detergent
flashes in the display.Excessive foam has
built up during
washing.Use less detergent next time
and follow the manufacturers
instructions on dosage given
on the packaging.
To switch off the fault message: Switch the machine off withI-On/0-Offbutton.
Problem solving guide
34 
						

							General problems
Problem Possible cause Remedy
The machine shakes
during the spin cycle.The machine feet are not
level.Level the machine (see
Installation and
connection).
The laundry has not been
spun properly and is still
wet.The machine detected an
imbalance during the final
spin and reduced the
spin speed automatically.Include both large and
small items in the load as
this will give better
distribution.
The laundry has not spun
satisfactorily.The spin speed selected
was too low.Select a higher spin
speed next time.
The pump makes strange
noises.This is not a fault! These noises occur at the end of a
pump sequence as a normal part of the operation.
There is a lot of
detergent residue in the
detergent drawer.The water pressure is too
low.– Clean the water inlet
filter.
– Select Water plus.
Powder detergent used
with water softeners can
be sticky.Add washing powder
and then add the water
softener.
Fabric conditioner is not
completely dispensed or
too much water remains
in thecompartment.The siphon tube is not
correctly positioned or is
clogged up.Clean the siphon, (see
Cleaning and care -
Cleaning the detergent
dispenser drawer).
The display is in a
different language.A different language has
been selected in the
Programmable functions
- Language
.Set the language you
want. The flag symbol
will guide you.
When laundry is dry, it
feels hard to the touch.Too vigorous wash action. Programme in gentle
action and more water.
Not enough detergent
used.Increase detergent dose
to prevent limescale
build-up in laundry.
No fabric conditioner
usedUse fabric conditioner in
last rinse.
Problem solving guide
35 
						

							An unsatisfactory wash result
Problem Possible cause Remedy
Liquid detergent
does not give the
required result.Liquid detergents
usually contain no
bleaching agents.
They do not remove
fruit, coffee and tea
stains.–Use a general purpose
detergent containing a
bleaching agent.
–Pour stain removers into
compartmentof the
dispenser drawer and liquid
detergent into a dispenser ball.
–Never put stain removers and
liquid detergent together in the
dispenser drawer.
Grey, greasy
particles cling to
washed laundry.Insufficient amounts of
detergent were used
to break down the
particles of grease in
heavily soiled laundry.– Use more detergent.
– Before washing the next load
run aCottons 95°Cprogramme
with powder detergent but
without a load.
A stale smell is in
the drum and on
laundry.Low temperature
washing.– Before washing the next load
run aCottons 95°Cprogramme
with powder detergent but
without a load.
White residues
which look like
powder detergent
are seen on dark
textiles after
washing.The detergent
contained compounds
(zeolites) to aid water
softening which are
not soluble in water.
They have ended up
on the laundry.–
Try and brush off the residues
with a soft brush once the
laundry is dry.
–
Wash dark textiles using a
detergent which contains no
zeolites. Liquid detergents
usually contain no zeolites.
–
Use theDark garments
programme.
Clothes are coming
out creased.The machine was
overloaded.–
Reduce quantity of clothes in
drum.
The wrong
programme was used.–
Check care labels and the
programme chart.
–
Use easy iron conditioners.
Problem solving guide
36 
						

							The drum door does not open when you press the Door button
Possible cause Remedy
The machine is not
connected to the
electricity supply and/or is
not switched on.Insert the plug in the socket and switch on and/or
switch the machine on with theI-On/0-Offbutton.
The safety lock has been
activated.Deactivate the safety lock as described in
Changing the programme sequence - Safety
lock.
Access via a code has
been activated.Deactivate the code as described in
Programmable functions - Code.
Power cut.Open the drum door as described in the next
section.
The door was not correctly
engaged.Press hard against the lock side of the drum door
and then press theDoorbutton.
There is still water in the
drum and the machine is
unable to drain.Clean the drain filter and drain pump as described
in the next section.
For safety reasons the drum door cannot be opened if the suds temperature is
higher than 55°C.
Problem solving guide
37 
						

							Opening the drum door in the
event of a blocked drain outlet
and/or power failure
Switch the washing machine off.
There is a lever behind the detergent
drawer fascia panel.
Remove the lever.

Use it to open the access flap.Blocked drain outlet
If the drain outlet is blocked, up to
25 litres of water will be retained in the
machine.
Caution: if laundry has been
washed at a high temperature, water
draining out of the machine will still
be hot. Danger of scalding!
Procedure for draining the machine
Place a suitable container under the
access flap.
When draining water from the
machine, donotunscrew the drain
filter completely or take it right out.

Unscrew the drain filter lid until water
runs out.
To interrupt the flow of water:

Tighten the drain filter back up again.
Problem solving guide
38 
						

							Once the flow of water ceases:
Remove the drain filter completely.
Clean it thoroughly.

Remove any foreign objects (e.g.
buttons, coins, etc.) and fluff from the
filter housing. Turn the impeller by
hand to check that it rotates freely.
Any foreign object causing an
obstruction should be removed.

Put the drain filter back in place and
secure.
Make sure the drain filter is
securely tightened. Otherwise there
is a risk of water leakage during use.
Opening the drum door
Always make sure that the drum
is stationary before reaching into the
machine to remove laundry.
Reaching into a moving drum is
extremely dangerous.

Pull the emergency release
downwards (see illustration). The
drum door will open.
Problem solving guide
39 
						

							In the event of any faults which you
cannot remedy yourself, please
contact:
–your Miele Dealer or
–Miele (see back cover for contact
details).
When contacting your Dealer or Miele,
please quote the model and serial
number of your machine, both of which
are shown on the data plate visible
above the porthole glass when the door
is open.
N.B. A call-out charge will be applied
for service visits where the problem
could have been resolved as
described in these instructions.Future updates (PC)
The indicator light marked PC is the
interface used by Miele service
technicians during servicing work for
testing purposes and for updating the
machines programme data.
Appliance guarantee
Please see the guarantee card
supplied with your machine.
Optional spare parts and accessories
Optional spare parts and accessories
for this washing machine are available
from your Miele Dealer, the Miele Spare
Parts Department or via the internet at
www.miele-shop.com.
Please note that telephone calls may
be monitored and recorded for
training purposes.
After sales service
40