Miele G 841 Dishwasher Manual

Running the dishwasher
^Make sure the spray arms are not
blocked.
^Close the door.
^Turn on the dishwasher.
The Start indicator (15) will flash.
^Select a wash program by turning the
program selector (16) to the left or
right. Refer to the Program guide for
details.
^
Press the Start button (15).
The program will begin.
Do not end a program prematurely!
Important program steps could be
omitted (e. g. reactivating the water
softener).
Waterproof System
All Miele dishwashers are specially de-
signed to...

At the end of a program
The End indicator will light when the
program has finished.
^Turn the program selector (16) to
Stop.
^Turn off the dishwasher.
^Open the dishwasher door slightly to
allow the dishes to cool before un
-
loading.
It is advisable to turn off the water
supply if the dishwasher will not be
used for a period of time (e.g. while
vacationing).
Interrupting a program
A program is interrupted as soon as the
door is opened.
If the door is closed, the program will
continue from where it was...

Program guide
Program When to use Program cycle
Pre-
wash
12Main
washInterim
rinse
12Final
rinseDry-
ing
Pots & Pans forheavily soiled pots and pans with dried on food
Main wash temperature170 °F (75 °C)
Run-time142 minXX X X - X X
Sani Wash extended wash time
forsanitizing normally soiled dishware with dried
on food
Main wash temperature150 °F (65 °C)
Run-time147 min-X X XX X X
Economy energy saving program
fornormally soiled dishware
Main wash temperature130 °F (55 °C)
Run-time103 min-- X X- X X
Normal...

With the aid of the following guide, minor problems can be fixed without a service
call.
,Repairs should only be carried out by a qualified and trained person in ac
-
cordance with local and national safety regulations. Unauthorized repairs could
cause personal injury or machine damage.
What if … Possible fault Fix
the dishwasher does not
start?The door is not properly
closed.Close the door firmly.
The machine is not
plugged in.Insert the plug.
The fuse is defective or
the breaker has tripped.Reset the...

What if … Possible fault Fix
the "Drain" indicator
flashes, the program
stops?Water intake error
–Turn off the dishwasher
before fixing the prob
-
lem.
–Open the water valve.
–Clean the water intake
filter, see maintenance
instructions.
Drain error, water left in
the wash cabinet–Turn off the dishwasher
before fixing the prob
-
lem.
–Clean the triple filter.
See maintenance in
-
structions.
–Clean the drain pump
and the non-return
valve, see maintenance
instructions.
–Remove any kinks in
the...

What if … Possible fault Fix
the "End", "Start" and
"Top Solo" indicators
flash at the same time at
the end of a program?There may be a technical
fault.–Turn the program selec
-
tor to ‘Stop.
–Turn off the dishwasher.
A few seconds later:
–Turn the dishwasher on.
–Select the desired pro
-
gram.
–Press the Start button.
If the indicators flash
again, there is a technical
problem.
–Call the Miele Technical
Service Department.
there is a knocking
noise in the wash cabi-
net?The spray...

What if … Possible fault Fix
dishes are not clean?The dishes were not
loaded correctly.See, Loading the dish
-
washer.
The program was not
powerful enough.Select a more intensive
program see, Program
guide.
Not enough detergent
was dispensed.Use more detergent, see,
Adding detergent.
The spray arm jets are
clogged.Clean the spray arm jets,
see, maintenance instruc
-
tions.
The triple filter is clogged
or not correctly seated.Clean and/or reseat the fil
-
ter, see, maintenance in
-
structions.
The drain...

What if … Possible fault Fix
glasses are dull and dis
-
colored and film cannot
be wiped off?Glasses are not dish
-
washer safe.There is no remedy.
Only wash dishwasher
safe glasses.
plastic items are discol
-
ored?Natural dyes e. g. from
vegetables may be the
cause. Not enough deter
-
gent was used to break
down natural dyes.Use more detergent, see
Adding detergent.
Discoloration is perma
-
nent.
there are rust stains on
cutlery?The salt reservoir cap was
not screwed on properly.Reseat and screw the...

In the event of a fault which you cannot
correct yourself please contact:
–Your Miele Dealer
or
–The Miele Technical Service Depart
-
ment.
USA 1-800-999-1360
[email protected]
CDN 1-800-565-6435
[email protected]
When contacting the Miele Technical
Service Department, please quote the
model and serial number of your appli-
ance.
These can be found on the data plate
on the upper inside edge of the dish-
washer door.Program update function - PC
The Program Correction (PC) allows a
technician to update...

To transport the dishwasher, e. g. when
moving to a new home, note the follow
-
ing:
–Empty the dishwasher.
–Secure any loose parts, e. g. hoses,
cables, cutlery baskets.
–Transport the dishwasher in the up
-
right position.
If unavoidable it may be transported
on its back.
Do not transport it on its side or on
the door. Residual water in the ma
-
chine could leak and cause electrical
damage.
Transport
40