Midway Skins Game Joystick Calibration Service Manual

							CALIBRATION NOTICE    16-11128 
 
 
Proper joystick calibration is essential to game play. When you first 
turn your Skins Game on, you should see a calibration screen and 
have an opportunity to reset potentiometer limits. Do not skip test. 
You must reset pot limits to ensure accuracy. 
If you do not see the calibration screen:  
1.  Enter Menu System by pressing TEST pushbutton on Test Switch Bracket. Wait 30 seconds. 
2. Select TESTS, then select CONTROLS TEST. You will see the screen below.
 
COIN MECHS  MISC 
1 2 3 4  TILT VOL + 
SVC   BILL  TEST VOL – 
START Keypd 
VIEW 
CLUB + 
CLUB – 
AIM LEFT 
AIM RIGHT  LAMP ON 
GRN=ok  RED= Sw ON.  YEL=Sw maybe. 
To activate LAMP, press START 
To reset pot limits, Press and hold START 
To activate coin counter, Press TILT Switch. 
To return to menu, Press and hold VIEW or CREDIT 
 
3.  Press and hold START button until center box and numbers surrounding it flash and turn red. 
4.  Pull joystick down as far as it will go. Observe that the dot in the box follows the movement 
of the joystick.
 
5.  Pull joystick left as far as it will go, then right as far as it will go. Observe that the dot 
movement reflects joystick movement.
 
6.  Release joystick to neutral position. Numbers turn green when calibration is done. 
7.  Press and hold VIEW button to return to TESTS menu. Press and hold VIEW again to return 
to Main Menu. Select EXIT TO GAME and press START button.
 
3A3 
0BA 
0BA 
Ctl Y 07F 1C5 304 
Ctl X 
1 2 3 
4 5 6 
7 8 9 
* 0 #