Midway Artic Thunder Game Operations Manual For 39 Dedicated Video Game

ARCTIC THUNDER7
Chapter 3 Service
VIEWING GLASS SERVICE
To service Viewing Glass...
It’s recommended that two service personnel be present when servicing viewing glass. Refer to Marquee
Service and Viewing Glass Service illustration. 
Switch off power to game machine and unplug AC line cord.
Remove center control cabinet.
1. Remove tamper-resistant screws from either side of cabinet used to fasten it to brackets attached to
the main cabinet. 
2. Slide control cabinet away from the main cabinet enough...

8MIDWAY AMUSEMENT GAMES, LLC 
Chapter 3 Service
To service Viewing Glass (continued)...
2.Grasp the bracket and lift the marquee housing up. The hinged marquee housing uses a prop rod
located inside the main cabinet to keep it extended during service. Remove the free end of the prop
rod from its retaining clip and insert it in the rod bracket on the lower right side of the marquee housing.    
Label and disconnect all wiring. Disconnect one end of the tension chain. Close the marquee. 
Remove the...

ARCTIC THUNDER9
Chapter 3 Service
To service the Monitor (CRT)…
We recommend that you read WARNINGS thoroughly before beginning this procedure.
Switch off power to game machine and unplug AC line cord.
Remove Marquee and Barrier Panel. Refer to service instructions for Marquee and Barrier Panel.    
Open rear cabinet door and disconnect monitor from wiring harness and ground wires. 
Facing the rear of the game cabinet, locate monitor clamp brackets attached to monitor chassis.
Loosen jam nut, then...

10 MIDWAY AMUSEMENT GAMES, LLC 
Chapter 3 Service
CONTROL CABINET SERVICE
To service the Control Cabinet…
Refer to Control Cabinet Service illustration. 
Switch off power to game machine and unplug AC line cord.
Remove the tamper resistant screws from either side of control cabinet used to fasten it to cabinet brack-
ets in the main cabinet.
Slide control cabinet halfway back along the rails to expose wiring. Label and disconnect all wiring. 
Continue to slide the cabinet away from the main cabinet...

ARCTIC THUNDER11
Chapter 3 Service
To service Blower Fan… 
Refer to Control Cabinet Service illustration. 
Switch off power to game machine and unplug AC line cord.
Remove center control cabinet.
1. Remove tamper-resistant screws from either side of cabinet used to fasten it to brackets attached to
the main cabinet. 
2. Slide control cabinet away from the main cabinet enough to expose wiring. 
3. Label and disconnect all wiring, including ground.
Continue to slide the cabinet completely away from the...

12 MIDWAY AMUSEMENT GAMES, LLC 
Chapter 3 Service
 To service Throttle (continued)…
3.Label and disconnect all wiring, including ground.
4. Completely remove controller cover and set aside until reinstallation.
Perform desired repair or equipment replacement.
Reconnect wires and reinstall. Check for pinched wires.
To service Controller… 
Refer to Controller Service illustration.
Switch off power to game machine and unplug AC line cord.
Open rear cabinet door.
Label and disconnect all dash wiring,...

ARCTIC THUNDER13
Chapter 3 Service
CONTROLLER SERVICE
AB
CD
E
F 

14 MIDWAY AMUSEMENT GAMES, LLC 
Chapter 3 Service
To service Steering Assembly…
Refer to General Dash Service illustration
Switch off power to game machine and unplug the AC line cord.
Unlock and open rear cabinet door.
Remove control cabinet:
1.Remove the tamper resistant screws from either side of control cabinet used to fasten it to brackets
in the main cabinet.
2.Slide control cabinet halfway back along the rails to expose wiring. Label and disconnect all wiring. 
3.Continue to slide the cabinet...

ARCTIC THUNDER15
Chapter 3 Service
To service Steering Assembly (continued)…
Pull plate forward to expose motor. Lift out steering assembly. NOTE
: Use caution when removing motor
due to its weight. 
Perform desired repair or equipment replacement.
While the steering mechanism is exposed, inspect belt for splits in the rubber or other signs of wear at the
edges of teeth. Install a new belt if necessary following the instructions below. 
To service Steering Belt…
Loosen four mounting nuts for the motor...

16 MIDWAY AMUSEMENT GAMES, LLC 
Chapter 3 Service
To service Lower Cabinet Speaker…
This speaker is located on the left-hand side of cabinet just above foot rest. 
Switch off power to game machine and unplug the AC line cord.
Remove control cabinet:
1.Remove the tamper resistant screws from either side of control cabinet used to fasten it to brackets
in the main cabinet.
2.Slide control cabinet halfway back along the rails to expose wiring. Label and disconnect all wiring. 
3.Continue to slide the...