Lucent Technologies DEFINITY Enterprise Communications Server Release 8.2 Installation And Test For Single-Carrier Cabinets Manual

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Accessing and Activating the System 
3-29 Set System Maintenance Parameters 
3
Set System Maintenance Parameters
1. Verify the sc reen d isp lays command: 
2. Type change system-parameters maintenance 
and press
 En te r. Verify 
that the sc reen d isp layed  is similar to Sc reen 3-7
. The sc reen shows 
d efault values and  the c ursor is positioned  on Product...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Accessing and Activating the System 
3-30 Administer Attendant Console 
3
Administer Attendant Console
1. Type craft
 at the login:
 prompt.
2. Type display system-parameters country-options
 and press 
En te r to 
verify the system’s c omp and ing  mod e for its loc al stations is set to the 
d esired  value (usually, A-Law for Europ e and  mu-Law for North Americ a...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Accessing and Activating the System 
3-31 Save Translations 
3
Screen 3-8. Typical Save Translation Screen
4. Verify a 0
 is d isp layed  in the Error Cod e c olumn for eac h Switc h 
Proc essing  Element (SPE). A 0
 ind ic ates the save translation was 
suc c essfully c ompleted . If a 0
 did  not ap p ear, the save translation d id  not 
c omp lete. Rec ord  the error...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Accessing and Activating the System 
3-32 Installation Completion 
3
Installation Completion
After the system is ac tivated , it must b e tested  for prop er op eration. See Chap ter 
4, ‘‘Test the System’’.
After c omp letion of the system tests, the telep hones and  other eq uip ment must 
b e installed . See Chap ter 5, ‘‘Install and  Wire Telep hones and  Other Eq...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Accessing and Activating the System 
3-33 DEFINITY AUDIX System Power Procedures 
3
DEFINITY AUDIX System Power 
Procedures
Manually Power Down AUDIX System
A yellow c aution stic ker on the system’s power unit notifies tec hnic ians to shut 
d own the DEFINITY AUDIX System p rior to p owering  d own the system.
1. Using  a p ointed  ob jec t, suc h as a pap er c lip  or...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Accessing and Activating the System 
3-34 DEFINITY AUDIX System Power Procedures 
3 

Test the System 
4-1  
4
DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
4
Test the System
The following tests verify the Time Division Multip lexing  (TDM) c ab les, 
terminators, and  the Inter-Cabinet Cab les (ICC). If a FAIL Result c od e is seen or 
other p rob lems are ind ic ated , c hec k these c ab les. If p rob lems p ersist, refer to 
DEFINITY Enterp rise Communic ations Server Release 8 Maintenanc e for...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Test the System 
4-2 Check System Status for Each Cabinet 
4
Check System Status for Each Cabinet
The system status may sug g est p rob lem areas.  Sp ecific tests later p rovid e more 
sp ec ific  d iag nostic  information.
1. Verify the terminal sc reen d isp lays:
command:
2. Type status system all-cabinets 
and press 
En t e r.
3. Verify the sc reen d isp lays system...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Test the System 
4-3 Check System Status for Each Cabinet 
4
Screen 4-2. Sample System Status Screen for Cabinet 2 (Page 2 of 3)
NOTE:
In the first sec tion of the rep ort in Sc reen 4-2, all Tone-Cloc ks should  
rep ort a SERVICE STATE
 of in
 for Cab inet 2.
In the sec ond sec tion of the rep ort, all TDM b uses should  rep ort a 
SERVICE STATE
 of in
.
In the third...

DEFINITY Enterprise Communication Server Release 8.2
Installation and Test for Single-Carrier Cabinets  555-233-120  Issue 1
April 2000
Test the System 
4-4 Check Circuit Pack Configuration 
4
Check Circuit Pack Configuration
The list configuration report provides a list of circuit packs c onnected to the 
system and  rec ognized  b y the software.
1. Verify the sc reen d isp lays command:
2. Type list configuration all 
and  p ress 
En t e r.
3. Verify the sc reen d isp lays list c onfig uration similar...