Home > Land Rover > Automobile > Land Rover Lr3 To Get Video On Your Touchscreen Display Woods Manual

Land Rover Lr3 To Get Video On Your Touchscreen Display Woods Manual

Add to Favourites
    Download as PDF

    View the Land Rover Lr3 To Get Video On Your Touchscreen Display Woods Manual for free. All the Land Rover manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 Woodman’s Guide To Get Video On Your Touchscreen Display For LR3/Discovery 3 or Range Rover 2006+ This guide is assumes that you have a LR3/Disco3 with the dealer fit DVD overhead system and want to get the video output from the DVD player on the front screen. Obviously parts of this guide can be adapted to suit as required, for example plugging a PS2 directly into the front screen. PHASE ONE - Preparing the overhead DVD player First thing to do is to get the video output connection sorted...
    Page 2 This now reveals a large opening where you can run the cable through the roof lining to the LHS of the vehicle along the door seal and down to the foot well where you can then leave the cable with enough slack to get up behind the front screen in a little while. You need to use a screened cable; I actually used a piece of audio cable (you can see it hanging down) for mine at it seems to work fine. Some others may prefer to use coax cable, if this is the case it must be 75ohm – NOT 50ohm...
    Page 3 Before you move into phase 2 – best you reinstall the DVD system otherwise it’s just a car full of plastic and screws!! PHASE TWO – The Touchscreen! Don’t be afraid here – it’s actually easier than it sounds, although you will need a steady hand with a fine tip soldering iron… but more of that later! To remove the touchscreen you need to remove the outer plastic surround from the dash. Basically its one hand down each side of the centre console, grab the back of the surround and pull –...
    Page 4 The core of the wire goes to the centre with the cable screen going to any one of the 4 points surrounding it. Here is an exploded view: Depending on which one you solder to, depends on which input it is on the touchscreen. Green is TV/DVD, Brown is Companion Cam and Tan is Reversing Cam. Once it’s soldered up, I insulated it with a small bit of PVC to stop the shield touching the earth like this: And I routed the cable out the back, so the finished result looked like this:...
    Start reading Land Rover Lr3 To Get Video On Your Touchscreen Display Woods Manual

    Related Manuals for Land Rover Lr3 To Get Video On Your Touchscreen Display Woods Manual

    All Land Rover manuals