Home
>
Honeywell
>
Control panel
>
Honeywell control panel VISTA128BPT250BPT128BPTSIA Security System User Manual
Honeywell control panel VISTA128BPT250BPT128BPTSIA Security System User Manual
Here you can view all the pages of manual Honeywell control panel VISTA128BPT250BPT128BPTSIA Security System User Manual. The Honeywell manuals for Control panel are available online for free. You can easily download all the documents as PDF.
Page 71
– 71 – Summary of Audible Notification (Alpha Display Keypads) SOUND CAUSE DISPLAY LOUD, INTERRUPTED* Keypad & External FIRE ALARM FIRE is displayed; descriptor of zone in alarm is displayed. LOUD, CONTINUOUS* Keypad & External BURGLARY/AUDIBLE EMERGENCY ALARM ALARM is displayed; descriptor of zone in alarm is also displayed. ONE SHORT BEEP (not repeated) Keypad only a. SYSTEM DISARM b. SYSTEM ARMING ATTEMPT WITH AN OPEN ZONE. c. BYPASS VERIFY a. DISARMED/READY TO ARM is...
Page 72
– 72 – FEDERAL COMMUNICATIONS COMMISSION STATEMENTS The user shall not make any changes or modifications to the equipment unless authorized by the Installation Instructions or Users Manual. Unauthorized changes or modifications could void the users authority to operate the equipment. FCC CLASS B STATEMENT This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for your information: This equipment generates and uses...
Page 73
– 73 – “FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 68 NOTICE This equipment complies with Part 68 of the FCC rules. On the front cover of this equipment is a label that contains, among other information, the FCC registration number and ringer equivalence number (REN) for this equipment. If requested, this information must be provided to the telephone company. This equipment uses the following jacks: An RJ31X is used to connect this equipment to the telephone network. The REN is used to...
Page 74
– 74 – CANADIAN DEPARTMENT OF COMMUNICATIONS (DOC) STATEMENT NOTICE The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational and safety requirements. The Department does not guarantee the equipment will operate to the user’s satisfaction. Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local...
Page 75
– 75 – WARNING! THE LIMITATIONS OF THIS ALARM SYSTEM While this system is an advanced design security system, it does not offer guaranteed protection against burglary or fire or other emergency. Any alarm system, whether commercial or residential, is subject to compromise or failure to warn for a variety of reasons. For example: Intruders may gain access through unprotected openings or have the technical sophistication to bypass an alarm sensor or disconnect an alarm warning device. ...
Page 76
– 76 – Index #70 Command ....................................... 46 4286 VIP Module .............................. 9, 46 AC Loss.................................................. 62 Access Another Partition ..................... 22 Access Control Commands ................... 54 Access Door ........................................... 45 Action Code ........................................... 53 Action Specifier ..................................... 53 Add a User...
Page 77
– 77 – LO Bat ................................................... 62 Low Battery ........................................... 66 Low Battery Warning ........................... 67 Macros ..................................................... 7 Manager................................................. 16 Master .................................................... 16 Master Keypad .................................. 8, 23 Maximum .......................................... 7, 22 MAXIMUM...
Page 78
– 78 – TWO YEAR LIMITED WARRANTY Honeywell International Inc., acting through its Security & Communications business (“Seller”), 2 Corporate Center Drive, Melville, New York 11747 warrants its products to be free from defects in materials and workmanship under normal use and service, normal wear and tear excepted, for 24 months from the manufacture date code; provided, however, that in the event the Buyer presents a proper invoice relating to the purchased product and such invoice bears a date...
Page 80
Ê800-06905EŠ 800-06905 6/10 Rev. C 2 Corporate Center Drive, Suite 100 P.O. Box 9040, Melville, NY 11747 Copyright © 2010 Honeywell International Inc. www.honeywell.com/security