Hitachi Cp-S220w Users Manual

							1-21
ENGLISH
T TR
RO
OU
UB
BL
LE
ES
SH
HO
OO
OT
TI
IN
NG
G 
 (
(c
co
on
nt
ti
in
nu
ue
ed
d)
)
Symptom
Before requesting repair, check in accordance with the following chart. If the situation cannot be
corrected, then contact your dealer.
Table 1-10. Symptom
SymptomPossible causeRemedyPage
The power is not
turned on.* main power switch is not
turned on.
* The power cord is
disconnected.* Turn on the main power switch.
* Plug the power cord into an AC
power outlet.
No video or audio.* The input is not correctly set.
* No signal input.* Use the projector or remote control
to set.
* Connect correctly.
Video is present but
no audio.
* The projector is not correctly
connected.
* The volume is seet to
minimum.
* Mute is turned on.* Connect correctly.
* Press VOLUME  on the remote
control or display the menu screen
and adjust the volume.
* Press the MUTE button.
Audio is present but
no video.
* The projector is not correctly
connected.
* The brightness adjustment
knob is rotated fully clockwise.
* The slide lens door is still
closed.* Connect correctly.
* Select BRIGHT with the MENU
button and the press the 
button.
* Open the slide lens door.
Colors are pale and
color matching is
poor.Color density and color
matching are not correctly
adjusted.Adjust the video.
Images are dark.
* Brightness and contrast are
not correctly adjusted.
* The lamp is nearing the end of
its service life.* Adjust the video.
* Replace with a new lamp.
Video is blurred.Focus or H PHASE is out of
adjustment.Adjust the focus or H PHASE.
The LAMP indicator
lights red.Lamp failure.Wait approximately 20 min. and
then turn the power on again.
The TEMP indicator
lights red.Internal overheating.
* Make sure the ventilation openings
are not blocked.
* Clean the air filter.
* Lower the ambient temperature to
35 degrees C or less.
The LAMP indicator
blinks red.* The lamp cover is not set
correctly.
* The lamp is not set correctly.* Check and correct the setting of
lamp cover and lamp. 
						

							1-22
SPECIFCATIONS
ItemSpecification
Product nameLiquid crystal projector
ModelCP-S220W
Liquid
crystal
panelPanel size1.8 cm (0.7 type)
Drive systemTFT active matrix
Pixels485,616 pixels (604 horizontal x 804 vertical)
LensZoom lens F=2.0 ~ 2.3  f=18 ~ 21 mm
Lamp130 W UHB
Speaker0.7 W
Power supplyAC100 ~ 120V, 2.0A / AC220 ~ 240V, 0.9A
Power consumption200 W
Temperature range0 ~ 35°C (Operating)
Size289 (W) x 70 (H) x 210 (D) mm
Weight (mass)2.38 kg or less
INPUT
signal
RGB
Video: Analog 0.7Vp-p, 75Ωterminator (positive)
H/V. sync.: TTL level (positive/negative)
Compound sync.: TTL level
D-sub 15-pin shrink jack
51
10
6
15
117Ground Green
8Ground Blue
9-
1Video input Red10Ground
2Video input Green11-
3Video input Blue12DDC jack
4-13H. sync./ Compound sync.
5Ground (DDC)14Vertical sync
6Ground Red15DDC jack
VIDEO1.0Vp-p, 75Ωterminator, RCA jack
S-VIDEO
Brightness signal: 1.0Vp-p, 75Ωterminator
Color signal: 0.286Vp-p (burst signal), 75Ωterminator
Mini DIN 4-pin jack
AUDIO200mVrms, 47 kΩor less (max. 3.0Vp-p)
Stereo mini jack (Speaker output is L/R mixed.)
CONTROL signal D-sub 15-pin shrink jack
NOTE: This specifications are subject to change without notice.
Table 1-11. Specifications 
						

							1-23
ENGLISH
S SP
PE
EC
CI
IF
FC
CA
AT
TI
IO
ON
NS
S 
 (
(c
co
on
nt
ti
in
nu
ue
ed
d)
)
Dimension Diagram
289
76
45.6
74.5
210
WARRANTY AND AFTER-SERVICE
* When a problem occurs, please check first using the Troubleshooting Chart provided in this
instruction manual. If the problem still persists, contact your dealer or service company.
* Repairs will be made as described in the warranty. For details, please read the warranty.
* Paid repairs will be made if desired in the event that the function can be restored by such repairs.Unit : mm
A warranty is provided for this product. Fill in the necessary items and store in a safe
place. 
						

							1-24
REGULATORY NOTICES
WARNING:This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
INSTRUCTIONS TO USERS:This equipment complies with the
requirements of FCC (Federal Communication Commission) equipments
provided that following conditions are met.
(1) Power cord: 
(2) Video inputs:
CAUTION:Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC Statement Warning
For the Customers in CANADA
NOTICE:This Class B digital apparatus complies with Canadian ICES-003. 
						

							9-1
TECHNICAL
TECHNICAL
Example of computer signal
Resolution H
×VfH (kHz)fV (Hz)RatingSignal modeDisplay
modeNote 1
640 ×35037.985.1VESAVGA-1Zoom in
640 ×40037.985.1VESAVGA-2Zoom in
720 ×40037.985.0VESATEXTZoom in
640 ×48031.559.9VESAVGA-3Zoom in
640 ×48035.066.7Mac13modeZoom inSW 1 ON
SW 2 ON
640 ×48037.972.8VESAVGA-3(72Hz)Zoom in
640 ×48037.575.0VESAVGA-3(75Hz)Zoom in
640 ×48043.385.0VESAVGA-3(85Hz)Zoom in
800 ×60035.256.3VESASVGA(56Hz)
800 ×60037.960.3VESASVGA(60Hz)
800 ×60048.172.2VESASVGA(72Hz)
800 ×60046.975.0VESASVGA(75Hz)
800 ×60053.785.1VESASVGA(85Hz)
832 ×62449.774.5Mac16modeZoom outSW 2 ON
SW 4 ON
1024 ×76848.460.0VESAXGA(60Hz)Zoom out
1024 ×76856.570.1VESAXGA(70Hz)Zoom out
1024 ×76860.075.0VESAXGA(75Hz)Zoom out
Note 1:  Mac adapter is necessary to the resolution mode.
Projector is compatible with 13 inch mode and 16 inch mode.
Mac 13 mode=switch 1 and switch 2 are ON.
Mac 16 mode=switch 2 and switch 4 are ON.
ON
OFF123456
Caution• Some computers may have multiple display screen modes. Use of some of these modes
will not be possible with this projector.
• Be sure to check jack type, signal level, timing and resolution before connecting this
projector to a computer.
• Depending on the input signal, full-size display may not be possible in some cases. Refer
to the number of display pixels above.
(Example 16 inch mode) 
						

							9-2
T TE
EC
CH
HN
NI
IC
CA
AL
L(
(c
co
on
nt
ti
in
nu
ue
ed
d)
)
Initial set signals
The following signals are used for the initial settings.
The signal timing of some computer models may be different. In such case, refer to pages 17 and 18
and adjust the V.POSIT and H.POSIT of the menu.
DATA
HSYNC
DATA
VSYNC
Display interval c Back porch b
Sync aFront porch d
Display interval c Back porch b
Sync aFront porch d
Computer /
SignalHorizontal signal timing (µs)
abcd
VGA-1(85Hz)2.03.020.31.0
VGA-2(85Hz)2.03.020.31.0
TEXT2.03.020.31.0
VGA-33.81.925.40.6
Mac 13mode2.13.221.22.1
VGA-3(72Hz)1.33.820.31.0
VGA-3(75Hz)2.03.820.30.5
VGA-3(85Hz)1.62.217.81.6
Computer /
SignalHorizontal signal timing (µs)
abcd
SVGA(56Hz)2.03.622.20.7
SVGA(60Hz)3.22.220.01.0
SVGA (72Hz)2.41.316.01.1
SVGA (75Hz)1.63.216.20.3
SVGA (85Hz)1.12.714.20.6
Mac 16mode1.13.914.50.6
XGA (60Hz)2.12.515.80.4
XGA (70Hz)1.81.913.70.3
XGA (75Hz)1.22.213.00.2
Computer /
SignalVertical signal timimg (lines)
abcd
VGA-1(85Hz)36035032
VGA-2(85Hz)3414001
TEXT3424801
VGA-323348010
Mac 13mode3394803
VGA-3(72Hz)3284809
VGA-3(75Hz)3164801
VGA-3(85Hz)3254801
Computer /
SignalVertical signal timimg (lines)
abcd
SVGA(56Hz)2226001
SVGA(60Hz)4236001
SVGA (72Hz)62360037
SVGA (75Hz)3216001
SVGA (85Hz)3276001
Mac 16mode3396241
XGA (60Hz)6297683
XGA (70Hz)6297683
XGA (75Hz)3287681