Home > Epson > Printer > Epson Stylus Photo RX690 User Manual

Epson Stylus Photo RX690 User Manual

Here you can view all the pages of manual Epson Stylus Photo RX690 User Manual. The Epson manuals for Printer are available online for free. You can easily download all the documents as PDF.

Page 31

Replacing Ink Cartridges31
English
9. Close the scanner unit.
10. Press OK.
The ink delivery system starts charging.
c
Caution:
❏Do not turn off the printer during ink 
charging as this will waste ink.
❏Do not press L[CD Print] until ink 
charging is complete.
Note:
If a message on the LCD screen still tells you 
that a cartridge should be replaced, the ink 
cartridges may not be installed properly. Press 
OK again, and press down the ink cartridge until 
it clicks into place.
 

Page 32

32Maintenance
Maintenance
Checking the Ink 
Cartridge Status
You can check which cartridge is low.
1. Press F[Setup].
2. Select Ink Levels, then press OK.
You see a graphic showing the ink 
cartridge status:
When your ink starts getting low,   is 
displayed.
3. Press yBack to return to the previous 
screen.
Note:
Epson cannot guarantee the quality or reliability 
of non-genuine ink. If non-genuine ink cartridges 
are installed, the ink cartridge status may not be 
displayed.
Checking and Cleaning 
the...

Page 33

Maintenance33
English
Cleaning the print head
Follow these steps to clean the print head so 
it can deliver ink properly. Before cleaning 
the print head, run a nozzle check to see if 
the print head needs cleaning (&“Checking 
the print head” on page 32). 
Note:
❏Make sure the CD/DVD guide is not ejected 
(&page 10).
❏Print head cleaning uses ink, so clean it only if 
quality declines.
❏When ink is low, you may not be able to clean 
the print head. When ink is expended, you 
cannot clean the print head....

Page 34

34Solving Problems
Solving Problems
See your online User’s Guide for help on 
using the printer with a computer.
Error Messages
Problems and Solutions
Setup problems
LCD screen and the mode light came on 
and then went out.
■The printer’s voltage may not match the 
outlet rating. Turn off the printer and 
unplug it immediately. Then, check the 
printer labels.
c
Caution
If the voltage does not match, DO NOT 
PLUG YOUR PRINTER BACK IN. Contact 
your dealer.
Error MessagesSolution
A printer error has...

Page 35

Solving Problems35
English
The printer makes noise after you turn it 
on.
■Make sure the protective tape is not 
blocking the print head.
After releasing the print head, turn off the 
power, wait a moment, then turn it back on.
The printer makes noise after ink cartridge 
installation.
■When you install ink cartridges, the ink 
delivery system must be charged. Wait 
until charging is finished (the charging 
message disappears from the LCD 
screen), then turn off the printer. If you 
turn it off too soon,...

Page 36

36Solving Problems
The paper jams
Removing jammed paper inside the 
printer
1. Press POn to turn off the printer.
2. Lift up the scanner unit.
3. Carefully remove any paper inside, 
including any torn pieces.
4. Close the scanner unit.
Note:
If the paper remains near the rear feeder, 
gently pull it out.
Removing jammed paper from the front 
paper cassette
1. Press POn to turn off the printer.
2. Close the output tray.
3. Pull out the front paper cassette and 
carefully remove any paper inside the...

Page 37

Solving Problems37
English
Removing jammed paper from the bottom 
of the printer
1. Press POn to turn off the printer and 
unplug the power cord from the printer 
and the electrical outlet.
2. Replace the paper support and remove 
the front paper cassette.
3. Carefully stand the printer on its side.
4. Carefully remove any paper inside, 
including any torn pieces.
5. Replace the printer and insert the front 
paper cassette.
6. Plug the power cord into the printer and 
the electrical outlet.
Removing...

Page 38

38Solving Problems
Your printout is blurry or smeared. 
■Make sure the document is placed flat 
against the document table. If only part of 
the image is blurred, your original may be 
wrinkled or warped.
■Make sure the printer is not tilted or 
placed on an uneven surface.
■Make sure your paper is not damp or 
curled.
■Make sure the printable side (the whiter 
or glossier side) of the paper is facing in 
the right direction.
■Make sure you select the correct paper 
type (&“Selecting Paper” on page 6)....

Page 39

Solving Problems39
English
Movie printing problems
The same thumbnail images are printed on 
one sheet.
■When you select Print N Frames as the 
movie printing method, if you set a short 
range for the movie, the same thumbnail 
images are printed on one sheet. Set a 
longer range for the movie and try again.
The printer does not play the movie.
■If you see a ? when you select the movie 
you want to play, the video codec for the 
movie data is not supported. Make sure 
that your movie data meets the...

Page 40

40Summary of Panel Settings
Summary of Panel Settings
Copy Mode
* These items are only displayed when the optional Auto Duplexer is attached.
MenuSetting ItemDescription
copies1 to 99-
Color/B&WColor, B & W-
DocumentText, Graphics, Photo-
LayoutWith BorderCopies your original with a standard 3-mm margin.
Double Side 1-up *Copies two originals on both sides of one sheet.
BorderlessCopies your photo all the way to the edges of the paper.
Note:
Your image is slightly enlarged and cropped to fill the sheet...
Start reading Epson Stylus Photo RX690 User Manual

Related Manuals for Epson Stylus Photo RX690 User Manual

All Epson manuals