Epson Powerlite Home Cinema 5010 Users Guide

							Notices81
■The following people should limit 3D content viewing:
People with a history of photosensitivity
People with heart disease
People in poor health
People who are sleep deprived
People who are physically tired
People under the influence of drugs or alcohol
Anyone who has ever experienced epileptic seizures or sensory disturbances triggered by flashing 
light effects
SOME LIGHT PATTERNS MAY INDUCE SEIZURES IN PERSONS WITH NO PRIOR 
HISTORY OF EPILEPSY.
■Never open any cover on the projector, except the lamp and filter covers. Dangerous electrical 
voltages inside the projector can severely injure you.
■Except as specifically explained in this User’s Guide, do not attempt to service this product 
yourself. Refer all servicing to qualified service personnel.
■The projector and its accessories come packaged in plastic bags. Keep plastic bags away from small 
children to avoid any risk of suffocation.
■Don’t place the projector on an unstable cart, stand, or table. Also, don’t use the projector near 
water or sources of heat.
■Use the type of power source indicated on the projector. If you’re not sure of the power available, 
consult your dealer or power company.
■Place the projector near a wall outlet where the plug can be easily unplugged.
■Don’t insert the plug into an outlet with dust present, and insert the plug firmly into the outlet. 
Failure to do so could result in sparks or fire.
■Don’t overload wall outlets, extension cords, or integral convenience receptacles. This can cause 
fire or electric shock.
■Don’t block the slots and openings in the projector case. They provide ventilation and prevent the 
projector from overheating. Don’t operate the projector on a sofa, rug, or other soft surface, or in a 
closed-in cabinet unless proper ventilation is provided.
■Never push objects through the cabinet slots or spill liquid into the projector.
■Unplug the projector from the wall outlet and refer servicing to qualified service personnel under 
the following conditions: when the power cord or plug is damaged or frayed; if liquid has been 
spilled into the projector, or if it has been exposed to rain or water; if it doesn’t operate normally 
when you follow the operating instructions, or if it exhibits a distinct change in performance, 
indicating a need for service; if it has been dropped or the housing has been damaged.
■Don’t place the projector where the cord can be walked on. This may result in fraying or damage 
to the plug.
■Unplug the projector from the wall outlet before cleaning. Use a damp cloth for cleaning. Do not 
use liquid or aerosol cleaners.
■ The lamp(s) in this product contain mercury. Please consult your state and local regulations 
regarding disposal or recycling. Do not put in the trash. 
						

							82Notices
■Allow the lamp to cool for one hour before replacing it.
■Unplug the projector during lightning storms or when not in use for extended periods.
■Don’t place the projector or remote control on top of heat-producing equipment.
■If you use the projector in a country other than where you purchased it, use the correct power cord 
for that country.
■Don’t stand on the projector or place heavy objects on it.
■Don’t use the projector outside of the required temperature range of 41 to 95 °F 
(5 to 35 °C). Doing so may cause an unstable display and could lead to projector damage.
■Don’t store the projector outside of the required temperature range of 14 to 140 °F 
(–10 to 60 °C) or in direct sunlight for long periods of time. Doing so may cause damage 
to the case.
WARNING: The cords included with this product contain chemicals, including lead, known to the 
State of California to cause birth defects or other reproductive harm. Wash hands after handling. (This 
notice is provided in accordance with Proposition 65 in Cal. Health & Safety Code § 25249.5 and 
following.)
FCC Compliance Statement
For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses, and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 
cause harmful interference to radio or television reception. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause interference to radio 
and television reception, which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following measures:
■Reorient or relocate the receiving antenna.
■Increase the separation between the equipment and receiver.
■Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected.
■Consult the dealer or an experienced radio/TV technician for help. 
						

							Notices83
WARNING
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC 
Certification of this device and may cause interference levels which exceed the limits established by the 
FCC for this equipment. It is the responsibility of the user to obtain and use a shielded equipment 
interface cable with this device. If this equipment has more than one interface connector, do not leave 
cables connected to unused interfaces. Changes or modifications not expressly approved by the 
manufacturer could void the user’s authority to operate the equipment.
For Canadian Users
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment 
Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le materiel brouilleur du 
Canada.
Copyright Notice
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or 
transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or 
otherwise, without the prior written permission of Seiko Epson Corporation. The information 
contained herein is designed only for use with this Epson product. Epson is not responsible for any use 
of this information as applied to other products.
Neither Seiko Epson Corporation nor its affiliates shall be liable to the purchaser of this product or 
third parties for damages, losses, costs, or expenses incurred by purchaser or third parties as a result of: 
accident, misuse, or abuse of this product or unauthorized modifications, repairs, or alterations to this 
product, or (excluding the U.S.) failure to strictly comply with Seiko Epson Corporation’s operating 
and maintenance instructions.
Seiko Epson Corporation shall not be liable for any damages or problems arising from the use of any 
options or any consumable products other than those designated as Original Epson Products or Epson 
Approved Products by Seiko Epson Corporation.
A Note Concerning Responsible Use of Copyrighted 
Materials
Epson encourages each user to be responsible and respectful of copyright laws when using any Epson 
product. While some countries’ laws permit limited copying or reuse of copyrighted material in certain 
circumstances, those circumstances may not be as broad as some people assume. Contact your legal 
advisor for any questions regarding copyright law. 
						

							84Notices
Trademarks
Epson, PowerLite, and C2Fine are registered trademarks, 1080Perfect is a trademark, and Epson Exceed Your 
Vision is a registered logomark of Seiko Epson Corporation.
PrivateLine is a registered trademark, DigiScan and AccuCinema are trademarks, and Extra Care and Epson 
Connection are service marks of Epson America, Inc.
HDMI, the HDMI logo, and High-Definition Multimedia Interface are registered trademarks 
of HDMI Licensing, LLC.
WirelessHD is a registered trademark of WirelessHD LLC.
General Notice: Other product names used herein are for identification purposes only and 
may be trademarks of their respective owners. Epson disclaims any and all rights in those 
marks.
This information is subject to change without notice.
© 2011 Epson America, Inc. 11/11
CPD-35484