Eiki Projector EK-600U User Manual

— 7 — 
DLP Projector — Owner’s Manual
Remote Control parts 
On
Test
Mode Pattern
Mous
e
Switch
Off
F1 F2
AV Mute
ENTER
Source VolumeV  Keystone
Info
.
VGA1
1
S-Video
2
HDMI1
3
HDMI2
FormatZoomRemote
IDAll
VGA2
4
Video
5
DVI
6
BNC
7
YPbPr
8
DisplayPort
9
3D
0
Re-Sync
Menu Pg
4
8
15
16
11
12
13
14
9
6
3
5
7
10
30
17
18
19
24
22
23
25
26
27
28
29
20
21
2
1
Important:
1.	Avoid	using	the	projector	with	bright	fluorescent	lighting	turned	on.	Certain	high-frequency	
fluorescent	lights	can	disrupt	remote	control...

— 8 — 
DLP Projector — Owner’s Manual
ItemLabeLDescrIptIonsee page
1Power on Turn projector ON. 11
2 Pattern Display a test pattern. -
3 Function button 
(F1) (Assignable) Programmable function button.
-
4 Mode/Mouse left 
click • 
Display mode menu on/off.
•  Use as mouse left click when mouse is switched on. -
5 Arrow Keys • Adjust a setting UP/DOWN or LEFT/RIGHT.
•  Navigate within a menu. 17
6 Info. Display source image information. -
7 Source Press “Source” to select an input signal. -
8 Menu...

— 9 — 
DLP Projector — Owner’s Manual
ItemLabeLDescrIptIonsee page
27DVI/6 • Select the DVI input source.
•  Use as numeric keypad number “6”. -
28 3D/0 • Select the 3D input source.
•  Use as numeric keypad number “0”. -
29 DisplayPort/9 • Select the Display port input source.
•  Use as numeric keypad number “9”. 66-67
30 Video/5 • Select the Composite Video input source.
•  Use as numeric keypad number “5”. -
 Caution:
Use	of	controls,	adjustments	or	performance	of	procedures	other	than	those	specified...

— 10 — 
DLP Projector — Owner’s Manual
Inserting the Remote Control batteries 
1. Remove the battery compartment cover as shown in the  
illustration.
2. Insert the batteries with correct polarity (+/-) as shown inside   
the battery compartment.
3. Replace the cover.
Caution: 
•	 Only use AAA batteries (Alkaline batteries are recommended). 
•	 Dispose of used batteries according to local ordinance regulations.
•	 Remove the batteries when not using the projector for prolonged periods.\
  

— 11 — 
DLP Projector — Owner’s Manual
Setup and OperatiOn 
Starting and Shutting down the projectorTurn the Projector On
1. Connect the power cord to the projector. Then connect the other end to a wall outlet.   
The Power button on the built in keypad is illuminated.
2. Remove the lens cap. 
3. Turn on the connected devices.
4. Turn on the projector by pressing “” on the remote control  
or on the built-in keypad. The Status LED is flashing Blue 
with a long blink. 
The projector splash screen displays...

— 12 — 
DLP Projector — Owner’s Manual
Turn the Projector Off
1. Press “” on the built-in keypad or press “” on the remote control to turn off the projector. A warning 
message will appear on the displayed image.
Power Off?
Press Power key again
2. Press “” on the built-in keypad or press “” on the remote control again to confirm your selection. If 
you do not press “
” or “” again, the warning message will disappear after 15 seconds.
Caution: 
•	 The cooling fans will continue to operate for about 10...

— 13 — 
DLP Projector — Owner’s Manual
Adjusting the projector level
Take note of the following when setting up the projector:
•  The projector table or stand should be level and sturdy.
•  Position the projector so that it is perpendicular to the screen.
•  Ensure the cables are in a safe location. You could trip over them.
A
B
40 mm
1. To raise the level of the projector, lift the projector A.
2. Locate the adjustable foot you wish to modify on the underside of the pr\
ojector.
3. Rotate the adjustable...

— 14 — 
DLP Projector — Owner’s Manual
Adjusting the Zoom, Focus, and Keystone
1. Use the Zoom lever to resize the projected  
image and screen size 
b.
2. Use the Focus lever to sharpen the   
projected image 
A.
3. Use the V Keystone button to adjust the keystone Volume V Keystone
VGA11S-Video2HDMI13HDMI2
FormatZoomRemoteIDAll
VGA24Video5DVI6BNC7YPbPr8DisplayPort93D0
MenuPg
Avertically and make a squarer image A.
Note:
Horizontal keystone can only be adjusted manually.
BA  

— 15 — 
DLP Projector — Owner’s Manual
projection SizeProjection Size v.s Throw Distance
EK-600U
DIagonaL 
Length(Inch)
sIze of16:10
 
screen
screen sIze W x h projectIon DIstance (D) offset (hD)
(
m) (Inch)(m)(feet)(cm)(feet)
W
IDthheIghtWIDthheIght WIDe teLeWIDe teLemaxmInmaxmIn
300.650.40 25.4 15.9 /1.4 /4.59  8.07 0.00 0.26 0.00 
40 0.860.54 33.9 21.2 1.01.93.28  6.23 10.77  0.00 0.35 0.00 
50 1.080.67 42.4 26.5 1.32.34.27  7.55 13.46  0.00 0.44 0.00 
60 1.290.81 50.9 31.8 1.62.85.25  9.19 16.16...

— 16 — 
DLP Projector — Owner’s Manual
Note:
•	Vertical Lens Shift values are always calculated from the Center of Proje\
ction Lens. Therefore the 
distance 5.2 cm (2.05 inch) from the Base to the Center of Projection \
Lens needs to be added to 
each Vertical Lens Shift value.
•	 Zoom ratio is 1.8x.
5.2 cm
H
D
1
3
32
Base
Wall
1. Center of projection lens.
2. Projection image while lens shift
 at the highest position.
3. Horizontal shift range: 10% H.