Bosch Dhi 655 F Manual

24
Before installation
Optimum efficiency of the extractor
hood:
❑
Short, smooth exhaust pipe.
❑
As few bends as possible.
❑
Pipe diameter as large as possible 
(ideally 150 mm dia.) and wide pipe
bends.
If long, rough exhaust-air pipes,
many pipe bends or smaller pipe 
diameters are used, the air extraction
rate will no longer be at an optimum
level and there will be an increase in
noise.
❑
Round pipes
Short exhaust air pipe:
inside diametermin. 120 mm,
Longer exhaust air pipe:
inside diametermin. 150...

25
Preparing the wall cupboard
This extractor hood is designed to be
installed in a wall cupboard with the follo-
wing dimensions:
width: 600 mm
depth: 293 to 350 mm
height: min. 435 mm.
If the cupboard is deeper than 293 mm,
the extractor hood can be moved back,
e.g. to put a spice rack in front of the
extractor hood.
To do this, place the template 
OIIfurther
back.

 Ensure that the cupboard is stable both
during and after installation, even if fitted at
the end of a row of kitchen units.
1.Mark two...

26
3.Tighten the two fixing screws with a 
screwdriver (cordless).
4.If required, shorten the wall cover to the
required dimension (e.g. saw off).
Attach the wall cover with the enclosed
clips.
Screw the wall cover to the wall 
cupboard.
5.Feed the mains connection cable out of
the cupboard.
6.Connect the pipes in the wall cupboard.
– If required, attach the air hose to the
cupboard ceiling –.
7.Re-insert grease filter 
(see Operating instructions).
Note: The extractor hood housing can be
clad inside the...

27
Fitting into wall cupboard
❑
If the extractor hood is to be installed
further back in the cupboard, the stops
for the filter drawer can be moved 
forwards.
❑
To do this, undo the screws, move the
stops and retighten the screws.
2.Align handle moulding and screw to the
appliance.Exhaust airCirculating air
13,013,5
We reserve the right to construction changes within the 
context of technical development.
Weight in kg:
Attaching the handle moulding:
A handle moulding must be attached to
the filter drawer....

28
Electrical connection
WARNING: THIS APPLIANCE MUST BE
EARTHED
IMPORTANT: Fitting a Different Plug:
The wires in the power cord are colour-
coded as follows:
Green and Yellow – Earth
Blue – Neutral
Brown – Live
If you fit your own plug, the colours of
these wires may not correspond with the
identifying marks on the plug terminals.
Proceed as follows:
1.Connect the green and yellow (Earth)
wire to the terminal in the plug marked
‘E’ or with the symbol (        ), or 
coloured green or green and yellow....

95
Notes 

Notes
96 

DHZ 4505
434229
13
4
2
53x
Aluminium: DHZ 4670
Metall: DHZ 4650
DHZ 4600
Absenkrahmen
Lowering frame
Du cadre 
d’abaissement
Befestigingsframe
Dei telai per 
l’abbassamento
Bastidor para bajar 

5750 203 748Printed in Germany    0704 Es.Robert Bosch Hausgeräte GmbH