Bissell 50c91 Manual

Replacing the hEpa media filter cartridge
the  hEpa media filter cartridge should be 
replaced every six months or if suction   
is declining. More or less frequent   
replacing may be required based on 
individual vacuuming habits and types of 
debris picked up.
1.   To remove the HEPA media filter   
cartridge, push down on the filter door 
latch and pull door away from the 
cleaner.
2.   Lift the tab at the top of the HEPA media 
filter cartridge and pull cartridge away 
from the cleaner.
3.   Replace...

Clearing clogs
low suction or poor pickup may be due to 
a clog in the vacuum cleaner. If you notice 
a change in the sound of the motor or a 
reduction in the spinning action in the dirt 
container, check for a clog.
If there is no suction or if suction is reduced 
at the hose, follow these steps to check for 
and clear the clog:
1. Unplug cleaner from electrical outlet.
2.  Check the foam filter and clean as   
necessary (see cleaning your foam filter 
on page 10).  
3.  Check the HEPA media filter and...

Clearing clogs continued
If suction is normal at the hose, follow these steps 
to check for and clear the clog for floor cleaning:
1.  Check diverter area at back of machine for 
diverter position and clogs. When the hose 
wand is inserted in the base, the diverter 
should be down. If a clog is visible near the 
diverter, the plastic cover may be removed to 
clear the clog by removing the 7 screws as 
shown in illustration on page 12.
2.   Check the foot hose for clogs (2a). If you are 
not able to tell...

14www.bissell.com 800.237.7691
Maintenance and care
Brush reset
If something becomes lodged in the foot and the 
brush shuts off, turn the cleaner off and unplug 
from the outlet. Remove the obstruction. the 
brush will automatically reset when the cleaner 
is plugged in and turned back on.
Brush maintenance
t he rotating brush should be checked regularly 
for accumulating debris that might reduce the 
cleaning performance of your vacuum.
1.  Unplug cleaner from electrical outlet.
2.  Recline the handle...

15www.bissell.com 800.237.7691
Changing the light bulb
1. Unplug cleaner from electrical outlet.
2.  Recline handle for easier access to light bulb 
and remove screw to lift off lens.
3.  Remove the bulb by grasping bulb and pull-
ing straight out of the socket. Install the new 
bulb by pushing gently into the socket until 
the bulb snaps into place.
TurboBrush maintenance
the  turbo brush should be checked regularly for 
clogs or debris wrapping around the brush.
1.  Remove tool from hose or front of...

16www.bissell.com 800.237.7691
Troubleshooting
Vacuum cleaner won’t turn on
possible causes  Remedies
1. Power cord not plugged in  1. Check electrical plug
2.  Blown fuse/tripped breaker  2. Check/replace fuse or reset breaker
3.  Thermal protector activated  3. Allow cleaner to cool for 30 minutes, see   
    pg. 13
4.  Handle not fully attached  4. Remove handle and reinstall
brush not rotating
possible causes    Remedies
1. Brush switch turned to “Off”   1. Make sure brush switch is in “On” position...

Troubleshooting
17www.bissell.com 800.237.7691
Vacuum cleaner is difficult to push
possible causes  Remedies
1.  Incorrect height setting  1. Turn dial to higher setting
Visible dust escaping from cleaner
possible causes  Remedies
1. Filter tray missing or not installed properly  1. Check filter tray to make sure it is   
    fully inserted
2.  Foam filter missing or not installed properly   2. Check foam filter for correct installation
3.   HEPA media filter cartridge missing or not  3. Check HEPA media...

18www.bissell.com 800.237.7691
For information about repairs or replacement parts, or questions about your warranty, call:
bISSEll Consumer Services 
1-800-237-7691
 
Monday - Friday    8 a.m. — 10 p.m. EST
Saturday    9 a.m. — 8 p.m. EST
Or write:
BISSELL HOMECARE, INC
PO Box 3606
Grand Rapids  MI 49501
ATTN: Consumer Services
 
Or visit the BISSELL website -  www.bissell.com
When contacting BISSELL, have model number of cleaner available.
Please record your Model Number: ___________________
Please...

19www.bissell.com 800.237.7691
you may purchase parts from your retailer, by calling  bISSEll Consumer Services or by  
visiting our website.  below is a list of common replacement parts*. While not all of these 
parts may have come with your specific model, they are available for purchase if desired.  
please note, all attachments may not store on board your vacuum.
Item  p art no.  p art name
1  28C2   HEPA Filter Cartridge
2  203-1374  Foam Filter
3  203-1362  TurboBrush
4  203-1372  TurboBrush with...

20www.bissell.com 800.237.7691
Warranty - BISSELL Heavy Duty Vacuum
 This warranty gives you specific legal rights, and you may also have other rights which may vary from state to 
state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, 
please contact BISSELL Consumer Services by E-mail, telephone, or regular mail as described below.
limited five year Warranty
Subject to the  *EXCEptIonS  anD EXClUSIonS identified below, upon receipt of the...