ATT Digital Magic On Hold Tape Deck Dmoh Installation Manual

  AT&T DMOH 
  Connecting a Power Supply 
  Connect the output plug from the power supply to the 12V AC/DC jack on the rear
panel of the unit. Plug the power supply into any convenient 110V AC outlet.
 
  Connecting to the Telephone System 
  Use the audio patch cord terminated with an RCA plug (included) to connect the LINE
600 ohm or 1 WATT output to the telephone systems music-on-hold (MOH) input.
Refer to page 9 for wiring connections. All MOH connections should be per the
specific telephone system...

AT&T DMOHImportant Notes:
1. The downloading process starts when audio signal is sensed, ensuring that
memory capacity will not be consumed during tape leader travel or for a delay of
the audio recording.
 
2. The audio RCA outputs do not operate during the downloading process.
Recording stops (and the RECORD indicator will go out) when 4 seconds of silence
has elapsed following the recording, or when memory capacity is exceeded, or when
the cassette tape reaches the end of its travel. After the message...

AT&T DMOHOptional External Trigger OperationExternal Trigger Operation is not required for most AT&T MOH
Applications
The unit can be set for single-play operation, activated by an external trigger. (Note:
the PLAY LED on the front panel illuminates only during digital playback.)
The TRIG mini-jack on the rear panel accepts a mono or stereo mini-plug, as shown
in the illustration below. When the plug is inserted, the unit automatically switches
to the single-play mode. (If the trigger is inserted during...

AT&T DMOHTroubleshootingPower LED does not light - Check power supply connection. Turn Power switch On.
Tape plays too fast - Remove cassette and tighten up any slack in the cassette.
Output too low or sounds distorted over telephone - Readjust volume or change
type of output used. Some telephone systems also have a volume control for the
MOH system; this may also require adjustment.
Cannot remove cassette because head is engaged - Turn power off and then on.
Wait for head to retract then remove...

AT&T DMOHWiring ConnectionDigital Magic On Hold Tape Deck
TELEPHONE
SYSTEMMUSIC ON HOLD CONNECTION (See
Note)OUTPUT
MERLIN(R)206,410,82
0PAGING CARTRIDGE #6102-MHPA1 WATTMERLIN 1030/3070SERVICES MODULE #61320A1 WATTMERLIN II
MERLIN LEGENDMUSIC COUPLER #61398A-THROUGH
LOOP START TRUNK PORT600 OHMMERLIN PLUSBUILT INTO CONTROL UNIT (MOH JACK)1 WATTPARTNER(R) II
PARTNER PLUS
SPIRIT(R)BUILT INTO CONTROL UNIT (MOH JACK)600 OHMSystem 25TIP/RING CIRCUIT PACK ZTN-78
(#62504A) or ANALOG LINE CIRCUIT
PACK TN742...

MERLIN, PARTNER, & SPIRIT are Registered Trademarks of AT&T
MAGIC ON HOLD is a Service Mark of AT&T
Note: Connect the Magic On Hold unit to the telephone system per the telephone system installation instructions for
Music-On-Hold.