Home > Aimco Brakes > Production Tools > Aimco Brakes OneShot Hammer RH100Z Operation Instructions User Manual

Aimco Brakes OneShot Hammer RH100Z Operation Instructions User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Aimco Brakes OneShot Hammer RH100Z Operation Instructions User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 85 Aimco Brakes manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							One-Shot Hammer 
    Model RH-100Z 
    OPERATION INSTRUCTIONS 
     10000 SE Pine Street, Portland, OR 97216 • (503) 254-6600 • Fax (503) 255-2615 • www.aimco-global.com 
     LIT-MAN600 Rev. 07/2016  Printed in USA ©2016 AIMCO 
    It is the responsibility of the employer to place the information in this manual into the hands of the operator. 
    WARNING 
    Important safety information enclosed. Read this manual before operating tool. Failure to observe the following warnings could result 
    in injury. 
    1. Never operate the hammer unloaded (unloaded or idle operation may damage the Rivet Snap Holder and release the Rivet Snap). 
    AIMCO shall not be responsible for accidents or problems caused by any misuse or abuse such as this. 
    2. Supply compressed air of 70~90 PSI. 
    3. Some air still remains in the hammer even after closing the Air Inlet Valve (P/No. 30) and will cause accidental operation when 
    lever is pushed down. Never neglect to practice the air releasing operation set forth in step #2 of Instructions for Safe Replacement 
    of Rivet Snaps. 
    IMPORTANT 
    Make sure that these instructions are fully understood before operating this tool. The tool, its attachments, and accessories must only 
    be used for their designed purpose. For product liability and safety reasons, any modifications of the tool and its accessories must be 
    agreed upon by the technical authority of the manufacturer. All locally legislated safety rules with regard to installation, operation, and 
    maintenance shall be respected at all times. 
    INSTRUCTIONS FOR SAFE OPERATION 
    First, follow your local safety regulations strictly on this tool. 
    1. Connect Air Hose to Air Inlet Valve (P/No. 30) and supply compressed air. 
    2. Put the Rivet Snap (P/No. 31) on the work and push the tool down lightly until the Rivet Snap sits firmly. 
    3. Push the Lever (P/No. 24) to start operation. 
    INSTRUCTIONS FOR SAFE REPLACEMENT OF RIVET SNAPS 
    1. Close the Air Inlet Valve (P/No. 30) to shut off air. 
    2. Put the Rivet Snap on something suitable and acceptable for trial shot-hammering and operate the hammer several times (refer to 
    the above-mentioned WARNING #3). 
    3. After making sure that the tool does not operate any more by pushing down the Lever, remove Retaining Ring (P/No. 29) and take 
    out Rivet Snap Holder and replace Rivet Snap. 
    MAINTENANCE 
    GENUINE PARTS: The use of other than genuine AIMCO replacement parts may result in safety hazards, decreased tool 
    performance, and increased maintenance, and may invalidate all warranties. 
    AIMCO is not responsible for customer modification of tools for applications on which AIMCO was not consulted. Repairs should be 
    made only by an authorized AIMCO Service Center. Contact AIMCO at 1-800-852-1368 for the authorized Service Center in your 
    area. 
      
    						
    All Aimco Brakes manuals Comments (0)

    Related Manuals for Aimco Brakes OneShot Hammer RH100Z Operation Instructions User Manual