Agio International Sling Spring Chair User Manual

							MODEL # 50-4460-702IMPORTANT NOTE:  Your sling seat may appear to be slightly warped.  This is not unusual.  
Proper assembly procedure will straighten out the sling seat in the frame. There are four bolts 
used to attach the seat frame to the seat base.  After inserting all the bolts, each of these bolts must be tightened a few revolutions at time in rotation.  
Step 1: Identify all parts packed in the carton against the parts list.  Remove all  protective 
            materials. Set parts on a flat, non-abrasive surface to avoid scratching.  If you are             missing  any parts or are unsure how to proceed with assembly, call our Customer             Service Center immediately at 1-800-416-3511.  Do not attempt to assemble chair
            if any parts are missing or damaged.
IMPORTANT NOTE: Assembling this chair requires attaching the chair frame to the chair
base.  We recommend two people work together to assemble the chair since it is critical that
all the holes in the chair frame are aligned exactly with the holes in the chair base.  All boltsneed to be inserted and tightened into the fixed nuts in a straight and direct path.  Insertingthe bolts at even the slightest angle could strip the nuts and bolts, damaging the entire chair.             Step 2: Working from behind the chair, have another person stand in front of the chair and 
            position the chair frame in between the arms of the chair base (as shown) so that the             holes on both sides of the upper portion of the chair frame back align with the fixed             nut holes in the chair base.             Step 3: From behind the chair, insert a bolt  through the hole on one side of back portion of 
            the chair frame and into the fixed nut hole in the back arm portion of the chair base.              (Bolt head will be towards the center of the chair back). Make sure the bolt is inserted             exactly straight!  Hand tighten 3-4 revolutions only.  DO NOT TIGHTEN 
            COMPLETELY. Repeat for opposite side of chair.  
Step 4: Working from the underside of the front of the chair, insert a bolt through the chair 
            frame and into the fixed nut holes in the chair base.  Hand tighten 3-4 revolutions             only. DO NOT TIGHTEN COMPLETELY.  Repeat for opposite side.
           Step 5: Tighten all bolts.  Each bolt must be tightened a 3-4 revolutions only at a time. Begin 
            with top left bolt.  Move to bottom right bolt then to top right bolt, followed by bottom             left bolt. Repeat this  X  pattern until all bolts are tight.  DO NOT OVER TIGHTEN
            BOLTS.  Over tightening  may strip bolts or nuts, damaging the entire chair. 
Step 6: Examine the chair from the front. If the sling seat does not appear tight or straight in 
            the seat base, repeat steps 3, 4 and 5.  If you do not feel your chair is assembled             properly, or you have any questions, call our Customer Service Center at 1-800-416-3511.Page 24 BOLT
1CHAIR BASE
CHAIR FRAME1
PARTS LISTPARTS LISTQTY./PCSQTY./PCSDESCRIPTION DESCRIPTION 
HEX WRENCH1IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!CHAIR FRAME 
(CROSS SECTION)CHAIR BASE 
(CROSS SECTION)