Agio International Sling Chair User Manual

							MODEL # 50-46490-487 IMPORTANT NOTE:  Your sling seat may appear to be slightly warped.  This is not unusual.  
Proper assembly procedure will straighten out the sling seat in the frame. There are four bolts 
used to attach the seat frame to the seat base.  After inserting all the bolts, each of these bolts must be tightened a few revolutions at time in rotation.  
             Set parts on a flat, non-abrasive surface to avoid scratching.  If you are 
            missing  any parts or are unsure how to proceed with assembly, call our Customer             Service Center immediately at 1-800-416-3511.  Do not attempt to assemble chair
            if any parts are  missing or damaged.
IMPORTANT NOTE: Assembling this chair requires attaching the sling seat frame to the 
seat base.  We recommend two people work together to assemble the chair since it is critical that all the holes in the seat frame are aligned exactly with the holes in the seat base.  All bolts need to be inserted and tightened into the fixed nuts in a straight and direct path.  Inserting the bolts at even the slightest angle could strip the nuts and bolts, damaging the entire chair.             
             that the holes on both 
            sides of the upper portion of the seat frame back align with the fixed nut holes in the seat base.             Step 3: From behind the chair, i
             
            exactly straight!  Hand tighten 3-4 revolution only.  DO NOT TIGHTEN 
            COMPLETELY. 
Working from the front of the chair, a(1/4x45mm).   From the underside 
            of the front seat support bar, insert bolt with washer                          COMPLETELY.  Repeat for opposite side.
           
            top left bolt.  Move to bottom right bolt then to top right bolt, followed by bottom left bolt.
            Repeat this “X” pattern until all bolts are tight.  DO NOT OVER TIGHTEN BOLTS.  Over
            tightening  may strip bolts or nuts, damaging the entire chair. 
Step 6: Examine the chair from the front. If the sling seat does not appear tight or straight in the
            seat base, repeat steps 3, 4 and 5.  If you do not feel your chair is assembled properly,            or you have any questions, call our Customer Service Center at 1-800-416-3511. Step 1: Identify all parts packed in the carton against the parts list.  Remove all  protective 
materials.
Step 2: Working from behind the chair, have another person stand in front of the chair and position
the sling seat frame in between the arms of the seat base (as shown) so
nsert a bolt (1/4x35mm) through the hole on one side of upper portion 
of the seat frame andinto the fixed nut in the back arm portion of the seat base.  Make sure the 
bolt is inserted 
Repeat for opposite side of chair.  
Step 4: dd a washer to a bolt 
through one of the holes in the seat support 
bar, into the fixed nut inside the lower front portion of the seat frame.  Hand tighten 3-4 revolutions only. DO NOT TIGHTEN 
Step 5: Tighten all bolts.  Each bolt must be tightened a 3-4 revolutions only at a time.  Begin with Page 2IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!PARTS LISTQTY. / PCSDESCRIPTION 
1/4x35MM BOLT
1/4x45MM BOLT
WASHER
HEX BOLT DRIVER
HEX WRENCH
2
1SEAT BASE
SEAT FRAME
1
1
1
2
2
1
2
3
4
5
6
7
4
3
3
4
FRONT SEAT SUPPORT BAR