Agio International Rectangular Inlaid Glass Table User Manual

							Page 2MODEL # 553860-22-487IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!12126699PARTS LIST DESCRIPTION PVC NUT COVERPVC BOLT COVERHEX BOLT DRIVERHEX WRENCH WASHER NUTTOPSIDE SUPPORTTABLE LEGLEG CONNECTOR
BRACKETTABLE RIMGLASS TOPQTY./PCS8811168241111/4x20MM BOLT1/4x25MM BOLT621
23456789
1011121313128799Step 1:CAREFULLY remove glass and set aside until 
           Step 7.  Lay glass flat--do not stand on edge.             Set parts on a flat, non-abrasive surface.  Remove           all protective materials.   Identify all parts packed            in carton against the parts list.  If you are missing            any parts, or are unsure how to  proceed with            assembly, call our Customer Service  Center at            1-800-416-3511.  Do not attempt to assemble the 
           table if any parts are missing or damaged.Step2: Place the table rim (without glass) upside down
Attach a leg to the rim using a (1/4x20mm)
bolt.  Add a washer to bolt, then guide this into the 
           pre-drilled hole already in place in the table rim.           Hand tighten bolts.  Repeat on the other three legs.
             on a flat, non-abrasive surface to avoid scratching
           the rim.             
           Important note:  Hand tighten bolts only for this step.
           Do not over tighten.  Some adjustments may be            necessary to ensure table legs are aligned properly.Step3:Attach a topside support to the rim using the 
           (1/4x20mm) bolt. Add a washer to each bolt, then
           guide into the pre-drilled hole in the table rim. Hand 
           tighten bolts.  Repeat on the other side. Important note:  
           Hand tighten bolts only for this step.  Do not over 
           tighten.  Some adjustments may be necessary to 
           ensure table legs are aligned properly.Step4:Attach a leg to the leg connector bracket by carefully 
           guiding the bolts already in place on the table legs (each
 through the holes in the leg connector 
bracket.  Add a washer and a nut to the end of each bolt.Hand tighten only. Repeat on other three legs.            leg has two bolts)
                      Step5:Using a (1/4x25mm) bolt, attach a topside support
           to the leg connector bracket. Add a washer to each bolt,           and guide this through the inside of the leg connector 
bracket, and into the fixed nut already in place in the topside support. Hand tighten only. Repeat for other side.            
           Step6:At this time, make any minor adjustments in the alignment
 Each bolt must be tightened a few
           revolutions at a time. In order to apply even pressure, we            of the table legs or topside supports. Once you have 
           legs and topside supports in the correct position, use the           Hex Bolt Drive and Hex Wrench provided to tighten all           nuts and bolts.  Note: 
           recommend you alternate between nuts and bolts, working
           in a cross corner (”X”) fashion. DO NOT OVER 
           TIGHTEN.  Cover all nuts and bolts with PVC covers.Step7:With the help of another person , turn the table in
           the upright position.  Note the clear bumpers spaced
CAREFULLY place the glass inside the rim, resting on 
 Your table is ready for use.
                       evenly throughout the inside of the table rim.  
                      the clear bumpers. 
If you have any questions, please call our customer
           service department (800) 416-3511.