Agio International Rectangular Captured Glass Table User Manual

							30-3860-15Page 2PART LISTDESCRIPTION
QTY./PCS
TABLE LEG
LEG CONNECTOR 
BRACKET
TABLE RIM 
WITH GLASS
 BOLT 
4
2
1
1
8
1
8
8
8
8
PVC BOLT COVER
WASHER
PVC NUT COVER
HEX BOLT DRIVER
NUTHEX WRENCHIMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!Step 1: Identify all parts packed in the carton 
          against the parts list. Remove all protective 
materials.  If you are missing any parts or are            
          unsure how to proceed with assembly, please          call our Customer Service Center immediately          at 1-800-416-3511.  Do not attempt to assemble
          the table if any parts are missing or damaged.Step 2: With the help of another person, place tabletop 
upside down on a flat,  non-abrasive surface to avoid scratching the glass and rim.  Note the 
nsert legs into
the plastic fittings of the rim.           
                    plastic fittings on the inside of the table rim.            These fittings slide.  Adjust, if necessary, by
          sliding the fittings into proper position in the           corners as shown in diagram below.  If applicable,          adjust the flat plastic supports so they are evenly           spaced between plastic fittings.  I          Step 3:Attach leg connector bracket (begin with the leg
        connector bracket closest to the table) by inserting         bolt through the table leg and leg connector bracket.         Secure bolt with nut. Hand tighten only (do not 
        fully tighten bolts at this time as some adjustments         may be necessary between the leg connector bracket         and the legs to ensure proper alignment  of the table         legs).  Repeat for remaining table legs.  Repeat          procedure for  remaining leg connector bracket. Step 4: Tighten all nuts and bolts using the Hex Bolt 
        Driver and Hex Wrench provided.   Important note:         each bolt should be tightened a few revolutions at         a time, alternating between bolts in a cross corner         (”X”) fashion. This will ensure your table is level         by placing equal pressure on all bolt joints.  Do not        over tighten.  Cover all nuts and bolts with         PVC covers provided.  Step 5: With the help of another person, carefully turn
        the table in the upright position.  Your table is  now 
        ready for use.  If you have any questions, please call         our Customer Service Center at1-800-416-3511.Plastic Fitting