Agio International Full Cushion Swivel Chair User Manual

							PARTS LIST DESCRIPTION 
1
1
PARTS LIST DESCRIPTION QTY./PCSQTY./PCS
CHAIR FRAME
SWIVEL BASE
NUT4
HEX WRENCH-11
PVC BOLT COVER
WASHER
1
4
4
 BOLT4
METAL PLATE2
SPRING WASHER4
HEX WRENCH-2Page 2      SEAT DESIGNS MAY 
VARY BUT THE ASSEMBLY 
             IS THE SAMEIMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!NOTE: MAKE SURE ARROWS
FROM BOTH THE “U” BARAND SWIVEL PLATE ARE
POINTING IN THE SAMEDIRECTION!MODEL # 50-19911U BARSWIVEL BASEMETAL PLATEWASHERSSWIVEL PLATESPRING WASHERSNUTSStep 1: Identify all parts packed in carton against the parts list.  Remove 
             all protective materials. Place parts on a non-abrasive surface 
             to avoid scratching.  If you are missing any parts or are unsure 
             how to proceed with assembly, please call our Customer Service 
             Center  immediately at 1-800-416-3511. Do not attempt to 
             assemble the chair if any  parts are damaged or missing.
IMPORTANT NOTE:  WE RECOMMEND TWO PEOPLE WORK 
TOGETHER TO ASSEMBLE THE CHAIR.
Step 2: Position the swivel base on a flat, solid surface.  Make sure the
             swivel plate is positioned all the way into the base.  It may have
             vibrated out during shipment.
Step 3: Note the arrows on both the swivel plate and the “U” bar portion
             of the chair frame.  Position the chair frame onto the swivel plate
             so that the two pairs of holes in the “U” bar are exactly aligned 
             with the two pairs of holes in the swivel plate and the arrows on
             both the “U” bar and swivel plate are pointing in the same direction.
             Proper positioning of the chair frame on the swivel plate/swivel
             base, and proper alignment of the holes in the “U” bar  with the
             holes in the swivel plate are critical to the safe, well balanced 
             swiveling motion of the chair.
Step 4: Carefully examine the diagram. Attach a metal plate to two (2) bolts 
             and guide the bolts through the top of one set of holes in the U bar 
             (located at  the bottom of the chair frame) and into the pair of holes in 
             the swivel plate. From beneath the swivel plate, add  a washer, then a 
             spring washer and a nut to the end each bolt. Hand tighten 3-4 
             revolutions only.  Repeat procedure for pair of holes on the  opposite  
             side.  Again, hand tighten nuts 3-4 revolutions only.  Do not tighten 
             nuts completely. 
Step 5:At this time tighten all nuts and bolts with the hex wrenches provided. 
             Do not over tighten.  Over tightening may strip the bolts and cause
             damage to the swivel plate, making the chair unsafe.
Step 6:Your chair should now be ready for use. If you do not feel that  your 
             chair is swiveling properly, double-check your assembly procedure, 
             especially step 3. If you have any  questions, please call our 
             Customer Service Center at 1-800-416-3511.CHAIR FRAME