Agio International Alumicast Swivel Chair User Manual

							MODEL # 50-1575911-742Page 2IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!      SEAT DESIGNS MAY 
VARY BUT THE ASSEMBLY 
             IS THE SAMEPARTS LIST DESCRIPTION 
1
1
PARTS LIST DESCRIPTION QTY./PCSQTY./PCS
CHAIR FRAME
CHAIR BASE
NUT4
4
HEX WRENCH-11
PVC BOLT COVER
WASHER
1
8
 BOLT4
2METAL PLATE
SPRING WASHER4
HEX WRENCH-2Step 1: Remove all protective materials and place all parts on a non-
             abrasive surface to avoid scratching before or during assembly. 
            Note parts and compare against the parts list.  If you are missing 
            any parts or are unsure how to proceed with assembly, please call 
            our Customer Service Center  immediately at 1-800-416-3511. 
            Do not attempt to assemble the chair if any  parts are damaged 
            or missing.
Step 2: Starting with the chair base, position it in front of you as shown in
             illustration with the holes in the swivel plate facing towards the rear 
            of chair base (away from you).  Important Note: Make sure that 
            the swivel plate is situated all the way into the chair base. It may 
            have  vibrated out of  place  during shipment.   With the help of 
            another person, position the chair frame onto the chair base with the 
            front of the seat facing you (see diagram) and the two sets of holes in 
            the U bar portion of the chair frame  aligned with the two sets of 
            holes in the swivel plate. This is very  important for a safe, balanced 
            swiveling  motion.  If chair frame  has been positioned properly onto
            the chair base, all arrows on both the “U” bar and the swivel plate will 
            be pointing in the same direction.
Step 3: Carefully examine the diagram. Attach a metal plate to  two (2) bolts 
             and guide the bolts through the top one set of holes in  the U bar 
             located at  the bottom of the chair frame. From beneath the swivel plate, 
             add a spring washer and a nut to the end each bolt. Do not  tighten nuts 
             completely at this time. Hand tighten only! Repeat procedure with other 
             set of holes on opposite side.
Step 4:At this time tighten all nuts and bolts with the hex wrenches provided. 
             Do not over tighten. Over tightening may strip the bolts and cause 
             damage to the swivel plate.
Step 5:Your chair should now be ready for use. If you do not feel your chair
             is swiveling properly, double-check your assembly procedure, especially
             steps 2 and 3. If you have any questions, please call our Customer Service 
             Center at 1-800-416-3511.SWIVEL PLATECHAIR BASESPRING WASHERSWASHERSMETAL PLATENUTSU BARBOLTSNOTE:
MAKE SURE ARROWS ON
BOTH THE U BAR AND 
SWIVEL PLATE ARE 
POINTING IN THE 
SAME DIRECTION.