Addonics Technologies Connector Converter ADIDESA User Manual

							 
ADDONICS TECHNOLOGIES 
Model: ADIDESA 
 
Installation Guide 
 
Front View 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Back View 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Note: It is required to set up the IDE hard drive you are 
connecting to the converter as a MASTER device. 
 
 
 
1. Locate the 40-pin IDE connector of your IDE drive.  
  
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
2. Connect the converter board to the IDE connector of the 
hard drive.  
 3. Using the provided Y-power cable, connect the 4-pin 
Molex connector to the power connector on the hard 
drive. This will provide power to the hard drive.  
 4. At the other end of the Y-power cable is the 4-pin floppy 
power connector which you connect to the converter. 
Now connect the SATA cable to the SATA port on the 
converter and the other end connect it to an onboard 
SATA port or an add-in SATA card.  
  
 
 
TECHNICAL SUPPORT 
 
Addonics Technologies            Phone: 408 433-3899 
2466 Kruse Drive             Fax: 408 433-3898 
San Jose CA 95131 
Email:  http://www.addonics.com/sales/query/ 
Internet:  http://www.addonics.com 
 
Technical Support (8:30 am to 6:00 pm PST) 
Phone:    408 433-3855 
Email: http://www.addonics.com/support/query/ 
 
SATA Port 
4-Pin Floppy Power Connector 
40-pin IDE Connector 
IDE Connector 
4-pin Molex Power Connector 
Master or Slave Jumper Settings