Accusplit Pedometer AX2720 User Manual

							VIEWING YOUR RESULTSOnce you put on your pedometer with the cover closed, 
it will automatically begin to record your steps, and 
activity time. Repeatedly press the red MODE button to 
cycle through the pedometer modes:  
STEP → ACTIVIT Y TIMER → STEP
4-Second STEP DELAY FILTERACCUSPLIT has added a “4-second step delay filter” to 
reduce the counting of “false steps”. When beginning 
walking, the display will not show any “tallying of new 
steps,” until af ter 4 seconds of walking. Then, all the 
STEPS will be added to the display and new STEPS 
continue to be counted and displayed.
RESETTING YOUR PEDOMETERMost people prefer to reset step counts daily. To reset: 
press and hold the white RESET button for at least 2 
seconds.
REPLACING THE BATTERYWhen the display star ts to dim or goes blank, it is time to 
replace the battery. Your pedometer uses one Type L1142 
(LR43) 1.5 volt battery. 
ACCUSPLIT AX2720  
Accelerometer Pedometer
INSTRUCTIONS
ACCUSPLIT, Inc.  •  7901 Stoneridge Drive, Suite 350  •  Pleasanton, CA 94588 USA
 800-935-1996  •  925-290-1900  •  FAX 925-290-1930  •  www.ACCUSPLIT.com  •  [email protected]
Congratulations on taking the first step to 
wellness with your purchase of an ACCUSPLIT  Accelerometer pedometer. 
It’s easy to set up your new pedometer. 
Just follow the steps below, and start walking!
180-1603
DISPLAY MODES 
•	 STEP:	STEP	mode	shows	your	 step	count	since	last	reset,	up	
to	100,000	steps.	
• 
◯:	ACTIVITY	TIMER	MODE	
shows	total	activity	time	in	
Hours,	Minutes	and	Seconds,	
since	last	reset,	up	to	10	Hours.	
The	timer	runs	automatically	
whenever	steps	are	being	
recorded.
WEARING YOUR PEDOMETER  Gently slide the pedometer onto your belt or the top edge 
of your pants or skir t. It should fit snugly and level, above 
one knee. The strong polycarbonate clip makes it easy.
Note: Your accelerometer pedometer no longer needs to 
be as ver tical as possible.
The cover should be closed to minimize objects hitting 
your pedometer. To avoid losing or dropping your 
pedometer, use the included leash and clip to fasten the 
pedometer securely to your clothing.
ATTACHING THE LEASHAttach the pedometer to the leash by looping the leash 
through the pedometer clip. Nex t, loop the leash through 
the metal clip, then clasp the waistband of your clothing 
with the pedometer belt clip.  
Note: You can also use a safety pin to fasten the leash 
to your clothing, loop the leash through your belt or belt 
loop, or use a badge holder.
First, loop the
pedometer leash clip
Next, loop the metal 
clip, then clasp clothing
Or, loop a  
badge holder,   
then put into pocket
(Badge holder   
not included)Or, loop a belt or belt loop
 
To  r e p l a c e :
1. Inser t a finger nail under the top right edge of the 
  battery door to lif t the door open and out of its slot.
2. Using a small “eye glasses” style screw driver,  
  remove the holding screw.
3. Remove the old battery and inser t the new  
  battery, + side up.
4. Replace the holding screw.
5. Carefully replace the battery door, first inser ting  
  the tab into its slot, then carefully pushing the cover  
  down until it snaps shut at the top edge.
Eat Right!  Walk More!  Live Well !   The ACCUSPLIT Lifestyle
POWER UP and DISPLAY ONPower UP the display, initially, from its battery saving, 
factory set, “hibernate mode”, by pressing a button for a 
second, until you see the display digits, then release the 
button.
Turn ON the display, from its battery saving “sleep mode” 
(which it enters af ter 5 minutes of no STEP counting) by 
moving your pedometer.