Home > Accusplit > Pedometer > Accusplit Pedometer AE2720STEP User Manual

Accusplit Pedometer AE2720STEP User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Accusplit Pedometer AE2720STEP User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 150 Accusplit manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							
    DISPLAY MODES 
    •	 step:	STEP	mode	shows	your	step	count	since	last	reset,	up	to	100,000	steps.	WEARING YOUR PEDOMETER
    While gently holding the belt clip open, slide the pedometer 
    onto your belt or the top edge of your pants or skirt. It should fit 
    snugly and level, above one knee. 
    Note: The pedometer should be as vertical as possible. 
    Walkers with larger stomachs may find it helpful to wear the 
    pedometer farther back on the body, toward one hip. 
    The cover must be closed for the pedometer to work. To 
    avoid losing or dropping your pedometer, use the included 
    leash and clip to fasten the pedometer securely to your 
    clothing. 
    Attaching the Leash: Attach the pedometer to the leash by 
    looping the leash through the pedometer leash slot. Next, loop 
    the leash through the metal clip. Finally, clasp the waistband of 
    your clothing with the metal clip. You can also use a safety pin to 
    fasten the leash to your clothing, loop the leash through your belt 
    or belt loop, or use a badge holder. 
    VIEWING YOUR RESULTS
    Once you put on your pedometer with the cover closed, it will 
    automatically begin to record your steps.
    RESETTING YOUR PEDOMETER
    Most people prefer to reset step counts daily. To reset: Press 
    and hold the white RESET button for at least 2 seconds.
    REPLACING THE BATTERY
    When the display starts to dim or goes blank, it is time to 
    replace the battery. Your pedometer uses one Type L1142 
    (LR43) 1.5 volt silver oxide battery. To replace:
    1.  Insert a coin into the slot on the front of the case, and twist 
    counterclockwise to loosen the battery door.
    2.  Remove battery door and take out the old battery. Replace 
    it with a new battery. The battery’s positive (+) terminal 
    should be FACE UP while you put it into the pedometer.
    3.  Put the battery door back on and twist the coin clockwise 
    to tighten.
    ACCUSPLIT AE2720STEP Pedometer
    INSTRUCTIONS
    ACCUSPLIT, Inc.  •  6120 Stoneridge Mall Rd., Suite 210  •  Pleasanton, CA 94588 USA
    800-965-2008  •  925-226-0888  •  FAX 925-463-0147  •  www.ACCUSPLIT.com  •  [email protected]
    Eat Right! Walk More! Live Well! 
    The ACCUSPLIT Lifestyle
    Congratulations on taking the first step to wellness with your 
    purchase of an ACCUSPLIT pedometer. Just put the pedometer 
    on as shown below, and start walking!
    970-061
    First, loop the
    pedometer leash slot
    Next, loop the metal 
    clip, then clasp clothing
    Or, loop a  
    badge holder,  
    then put into pocket(Badge	holder		
    not	included)Or, loop a belt or belt loop
    9789
    White: RESET 
    						
    All Accusplit manuals Comments (0)

    Related Manuals for Accusplit Pedometer AE2720STEP User Manual