Home > Accusplit > Pedometer > Accusplit Pedometer AE1720WPR User Manual

Accusplit Pedometer AE1720WPR User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual Accusplit Pedometer AE1720WPR User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 150 Accusplit manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							
    DISPLAY MODES 
    • STEP: STEP mode shows 
    your step count since last reset, 
    up to 1,000,000 steps. 
    • 
    ◯: ACTIVITY TIMER 
    MODE shows total activity 
    time in minutes and seconds 
    since last reset. The timer runs 
    automatically whenever steps  
    are being recorded.
    Adjusting your Pedometer’s 
    Measurement Sensitivity AE1700 
    pedometers are highly accurate step 
    counters. However, some walkers may 
    find that their step counts tend to be 
    a bit too high, or too low. All AE1700 
    models come with a sensitivity adjust-
    ment, to help account for individual 
    differences. The adjustment switch has 
    three positions: “+,” “-,” and center. 
    The adjustment switch is located on the 
    bottom of the pedometer, on the right-
    hand side when looking from the front.
    Adjustment Procedure: Take 100 steps, 
    then check STEPS display to see how 
    many steps were actually counted. 
    Repeat once to make sure results are 
    about the same. If the pedometer counts 
    fewer steps than you actually walked, 
    slide the sensitivity adjustment towards 
    the “+” icon. This will increase recorded 
    steps by about 10%. If the pedometer 
    counts more steps than you actually 
    walked, slide the sensitivity adjustment 
    towards the “-” icon. This will decrease 
    recorded steps by about 10%.
    WEARING YOUR PEDOMETER
    While gently holding the belt clip open, 
    slide the pedometer onto your belt or the 
    top edge of your pants or skirt. It should 
    fit snugly and level, above one knee. 
    Note: The pedometer should be as 
    vertical as possible. Walkers with larger 
    stomachs may find it helpful to wear the 
    pedometer farther back on the body, 
    toward one hip. The cover must be closed 
    for the pedometer to work. To avoid 
    losing or dropping your pedometer, use 
    the included leash and clip to fasten the 
    pedometer securely to your clothing. 
    Attaching the Leash: Attach the 
    pedometer to the leash by looping the 
    leash through the pedometer leash slot. 
    Next, loop the leash through the metal 
    clip. Finally, clasp the waistband of your 
    clothing with the metal clip. You can also 
    use a safety pin to fasten the leash to 
    your clothing, loop the leash through your 
    belt or belt loop, or use a badge holder. 
    ACCUSPLIT AE1720WPR Series Pedometer
    INSTRUCTIONS
    ACCUSPLIT, Inc.  •  6120 Stoneridge Mall Rd., Suite 210  •  Pleasanton, CA 94588 USA
    800-965-2008  •  925-226-0888  •  FAX 925-463-0147  •  www.ACCUSPLIT.com  •  [email protected]
    Eat Right!  Walk More!  Live Well!  
    The ACCUSPLIT Lifestyle
    Congratulations on taking the first step to wellness 
    with your purchase of an ACCUSPLIT pedometer. 
    It’s easy to set up your new pedometer. 
    Just follow the steps below, and start walking!Red: 
    MODE
    9789ACCUSPLIT EAGLE
    �STEP▶
    White: 
    RESET 
    970-071
    First, loop the pedometer leash slot
    Next, loop the metal clip, then clasp clothing
    Or, loop a  badge holder,  then put into pocket(Badge holder  not included)Or, loop a belt or belt loop
    VIEWING YOUR RESULTS
    Once you put on your pedometer with the 
    cover closed, it will automatically begin 
    to record your steps, and activity time. 
    Repeatedly press the red MODE button to 
    cycle through the pedometer modes: 
    STEP → ACTIVITY TIMER → STEP
    RESETTING YOUR PEDOMETER
    Most people prefer to reset step counts 
    daily. To reset: press and hold the white 
    RESET button for at least 2 seconds.
    REPLACING THE BATTERY
    When the display starts to dim or goes 
    blank, it is time to replace the battery. 
    Your pedometer uses one Type L1142 
    (LR43) 1.5 volt silver oxide battery.  
    To replace:
    1.  Insert a coin into the slot on the front 
     
      of the case, and twist counterclock-
     
      wise to loosen the battery door.
    2.  Remove battery door and take out the 
     
      old battery. Replace it with a new 
     
      battery. The battery’s positive (+) 
     
      terminal should be FACE UP while you 
     
      put it into the pedometer.
    3.  Put the battery door back on and twist 
     
      the coin clockwise to tighten.
    You are also helping to support the cause of breast cancer 
    awareness and research. A portion of the proceeds from your 
    purchase will be donated to a breast cancer initiative.  
    						
    All Accusplit manuals Comments (0)

    Related Manuals for Accusplit Pedometer AE1720WPR User Manual