Accusplit Pedometer AE1720 User Manual

							
DISPLAY MODES 
• step: STEP mode shows your 
step count since last reset, up  
to 100,000 steps. 
•  ACTIVITY TIMER MODE 
shows total activity time in 
minutes and seconds since  
last reset. The timer runs 
automatically whenever steps  
are being recorded.Adjusting your Pedometer’s 
Measurement Sensitivity AE1700 
pedometers are highly accurate step 
counters. However, some walkers may 
find that their step counts tend to be 
a bit too high, or too low. All AE1700 
models come with a sensitivity adjust-
ment, to help account for individual 
differences. The adjustment switch has 
three positions: “+,” “-,” and center. 
The adjustment switch is located on the 
bottom of the pedometer, on the right-
hand side when looking from the front.
Adjustment Procedure: Take 100 steps, 
then check STEPS display to see how 
many steps were actually counted. 
Repeat once to make sure results are 
about the same. If the pedometer counts 
fewer steps than you actually walked, 
slide the sensitivity adjustment towards 
the “+” icon. This will increase recorded 
steps by about 10%. If the pedometer 
counts more steps than you actually 
walked, slide the sensitivity adjustment 
towards the “-” icon. This will decrease 
recorded steps by about 10%.
WEARING YOUR PEDOMETER
While gently holding the belt clip open, 
slide the pedometer onto your belt or the 
top edge of your pants or skirt. It should 
fit snugly and level, above one knee. 
Note: The pedometer should be as 
vertical as possible. Walkers with larger 
stomachs may find it helpful to wear the 
pedometer farther back on the body, 
toward one hip. The cover must be 
closed for the pedometer to work. To 
avoid losing or dropping your pedometer, 
use the included leash and clip to fasten 
the pedometer securely to your clothing. 
Attaching the Leash: Attach the 
pedometer to the leash by looping the 
leash through the pedometer leash slot. 
Next, loop the leash through the metal 
clip. Finally, clasp the waistband of your 
clothing with the metal clip. You can also 
use a safety pin to fasten the leash to 
your clothing, loop the leash through your 
belt or belt loop, or use a badge holder. 
ACCUSPLIT AE1720 Series Pedometer
INSTRUCTIONS
ACCUSPLIT, Inc.  •  6120 Stoneridge Mall Rd., Suite 210  •  Pleasanton, CA 94588 USA
800-965-2008  •  925-226-0888  •  FAX 925-463-0147  •  www.ACCUSPLIT.com  •  [email protected]
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts 
daily. To reset: press and hold the white 
RESET button for at least 2 seconds.
REPLACING THE BATTERY
When the display starts to dim or goes 
blank, it is time to replace the battery. 
Your pedometer uses one Type L1142 
(LR43) 1.5 volt silver oxide battery.  
To replace:
1. Insert a coin into the slot on the front 
 
  of the case, and twist counterclock-
 
  wise to loosen the battery door.
2.  Remove battery door and take out the 
 
  old battery. Replace it with a new 
 
  battery. The battery’s positive (+) 
 
  terminal should be FACE UP while you 
 
  put it into the pedometer.
3.  Put the battery door back on and twist 
 
  the coin clockwise to tighten.
Eat Right!  Walk More!  Live Well!  
The ACCUSPLIT Lifestyle
Congratulations on taking the first step to wellness 
with your purchase of an ACCUSPLIT pedometer. 
It’s easy to set up your new pedometer. 
Just follow the steps below, and start walking!Red: 
MODE
9789ACCUSPLIT EAGLE
White: 
RESET 
970-051
First, loop the pedometer leash slot
Next, loop the metal clip, then clasp clothing
Or, loop a  badge holder,  then put into pocket(Badge holder  not included)Or, loop a belt or belt loop
VIEWING YOUR RESULTS
Once you put on your pedometer with the 
cover closed, it will automatically begin 
to record your steps, and activity time. 
Repeatedly press the red MODE button to 
cycle through the pedometer modes: 
STEP → ACTIVITY TIMER → STEP