Accusplit Pedometer AE1620 User Manual

							
WEARING YOUR PEDOMETERWhile gently holding the belt clip open, slide the pedometer onto your belt or the top edge of your pants or skirt. It should fit snugly and level, above one knee. Note: The pedometer should be as vertical as possible. Walkers with larger stomachs may find it helpful to wear the pedometer farther back on the body, toward one hip. The cover must be closed for the pedometer to work. To avoid losing or dropping your pedometer, use the included leash and clip to fasten the pedometer securely to your clothing. 
Attaching the Leash: Attach the pedometer to the leash by looping the leash around the pedometer belt clip. Next, clasp the waistband of your clothing with the attached metal clip. You can also use a safety pin to fasten the leash to your clothing, loop the leash through your belt or belt loop, or use a badge holder. 
VIEWING YOUR RESULTSOnce you put on your pedometer with the cover closed, it will automatically begin to record your steps. 
ACTIVITY PEDOMETER
OPERATING INSTRUCTIONS
ACCUSPLIT, Inc.  •  6120 Stoneridge Mall Rd., Suite 210  •  Pleasanton, CA 94588 USA
800-965-2008  •  925-226-0888  •  FAX 925-463-0147  •  www.ACCUSPLIT.com  •  [email protected]
ACCUSPLIT®
       EAGLE™ 1620
Eat Right!  Walk More!  Live Well! 
The ACCUSPLIT Lifestyle
Congratulations on taking the first step to wellness with your purchase 
of an ACCUSPLIT pedometer. It’s easy to set up your new pedometer. 
Just follow the steps below, and start walking!
970-066
First, loop the pedometer clip
Next, loop the metal clip, then clasp clothing
Or, loop a  badge holder, then  put into pocket(Badge holder not included)
Or, loop a belt or  belt loop
NO-PROOF-OF-PURCHASE LIMITED WARRANTYSee label inside the lid of the pedometer.
DISPLAY MODES•  STePS:  Counts steps taken since last ReSeT.  
  Reset daily to count each day’s steps.
AUTO MOVEMENT SENSOR1. To filter out random movements, the unit remains in standby mode until  
  5 continuous steps are registered. Only then are the 5 steps calculated \
in,  
  and an Active indicator “▲” appears on the upper left of display.
2.  When regular walk/run movement stops, after 2 seconds the timer pauses 
 
  and the unit switches to standby status (Active indicator “▲” disappears)
RESETTING YOUR PEDOMETER Most people prefer to reset step counts daily. To reset: Press and hold yellow 
ReS eT button for at least two seconds to reset to zero. 
REPLACING THE BATTERYWhen the display starts to dim or goes blank, it is time to replace the battery. Your pedometer uses one Type LR43 (L1142) 1.5 volt alkaline battery. To replace:
1.  Insert a coin into the slot on the bottom of the case, and twist counter-
 
  clockwise to loosen the case front. Lift case front away.
2.  Using a pen or other thin object, push battery sideways out of its holder. 
 
  Replace it with a new battery. The battery’s positive (+) terminal should  
  be FACe UP while you put it into the pedometer.
3.  Align case front over the pedometer and press gently to 
 
  snap cover back into place, starting with top.
ACCUSPLIT EAGLE 1620
TW15MG
STEP
RESET
MY 10K-A-DAY™
425 I Yellow:
ReSeT
REGISTER NOW Please return your AE1620 Registration to the Repair Center address in the warranty, and we will let you know about future products. 
Email (preferred)
User