Accusplit Pedometer AE1120M2 User Manual

							WEARING YOUR PEDOMETER
While gently holding the belt clip open, slide the pedometer 
onto your belt or the top edge of your pants or skirt. It should 
fit snugly and level, above one knee. 
Note:  The pedometer should be as vertical as possible. 
W alkers with larger stomachs may find it helpful to wear the 
pedometer farther back on the bod y, toward one hip. 
T o avoid losing or dropping your pedomete r, use the included 
leash and clip to fasten the pedometer securely to your 
clothing. 
Attac hing the Leash:  Attach the pedometer to the leash by 
looping the leash around the pedometer belt clip. Next, clasp 
the waistband of your clothing with the attached clip.  Y ou can 
also use a safety pin to fasten the leash to your clothing, loop 
the leash through your belt or belt loop, or use a badge holde r. 
VIEWING  YOUR RESUL TS
Once you put on your pedomete r, it will automatically begin 
to record your steps. Press the DA Y button to view today’s 
step count. Press the  TOT AL button to view total steps taken.
MEMOR Y PEDOMETER
OPERA TING INSTRUCTIONS
ACCUSPLIT , Inc.  •  3090 Independence Drive, Suite 148  •  Livermore, CA 94551 USA
800-935-1996  •  925-290-1900  •  FAX 925-290-1930  • www.ACCUSPLIT .com  •  support@ACCUSPLIT .com
ACCUSPLIT®
       EAGLE
™ 11 20 M 2
Congr atul atio ns o n ta kin g th e fi rst s te p to  welln ess  w it h  y ou r pu rc h ase  o f a n A CC USPLIT  
pedom ete r. I t’s  e asy to  s e t u p y ou r ne w pedom ete r.  Ju st  follo w th e s te ps bel ow , an d s ta rt wa lk in g!
RESETTING  YOUR PEDOMETER
M ost peopl e pr efe r to  r e se t s te p cou nts  dai ly .   
T o  re se t:  W hil e di splayin g Day’ s S tep s, pres s an d hol d D AY  
b utto n fo r a t le ast  thre e secon ds to  r e se t to  z er o. W hen   
di splayin g T o ta l S tep s, pres s T O TA L b utto n fo r thre e s e con ds   
t o  re se t T o ta l  an d Day’ s S tep s to  zer o.
A UT O MO VEMENT SENSOR
1.  To filter out random movements, the unit remains in standby   
  mode until 5 continuous steps are registered. Only then are   
  the 5 steps calculated in, and an  Active indicator “ ▲” appears  
  on the upper left of displa y.
2.  When regular walk/run movement stops, after 2 seconds the  
  timer pauses and the unit switches to standby status (Active   
  indicator “ ▲” disappears). 
REPLA CING THE B ATTER Y
When the display starts to dim or goes blank, it is time to replace 
the battery . Y our pedometer uses one  T ype L
1142 (LR43) 1.5 
volt silver oxide batter y.  To replace:
1 .  U sin g a  jeweler ’s s crewdr iv e r,  lo ose n s mal l   s cre w o n b ack  o f  
  unit.  Rem ove  b ack  o f ca se .
2.  Slide the old battery gently out of its holde r. Replace it with a   
  new battery . The battery’s positive (+) terminal should be   
  FACE UP  while you put it into the pedomete r.
3.  Gently press front and back of pedometer   case back togethe r,   
  being sure to line up slots and tabs at top and bottom of unit.
AC CUSPL ITEAG LE
1 1 2 0M 2
T W 15 M G
T
O T
A L D
A
YAccuSTEP1 00 00.orgS T
T L
MODES
•   “D”–  “Day’ s Steps”
  Counts steps tak en since last RESET .
•  “T”–”T otal Steps”
  Keeps trac k of all steps tak en, even after  
  Day’ s Steps are reset.
DAY but ton
T O TAL but ton
970-043
First, loop the 
pedomet er clip
Next,  loop the metal 
clip,  then clasp clothing
Or, loop a   
badg e holder , then  
 put int o pocket
(Badge holder   
not included)
Or , loop a belt   
or belt loop
REGISTER NOW Please return 
your AE1120M2 Registration to 
the Repair Center address in the 
warranty , and we will let you 
know about future products.  Email (preferred)
User