Accusplit Pedometer AE1120 User Manual

							WEARING YOUR PEDOMETER
While gently holding the belt clip open, slide the pedometer 
onto your belt or the top edge of your pants or skirt. It should fit 
snugly and level, above one knee. 
Note: The pedometer should be as vertical as possible. Walkers 
with larger stomachs may find it helpful to wear the pedometer 
farther back on the body, toward one hip. 
To avoid losing or dropping your pedometer, use the included 
leash and clip to fasten the pedometer securely to your clothing. 
Attach\fng the \beash: Attach the pedometer to the leash by 
looping the leash around the pedometer belt clip. Next, clasp 
the waist-band of your clothing with the attached clip. You can 
also use a safety pin to fasten the leash to your clothing, loop 
the leash through your belt or belt loop or use a badge holder. 
OPERATING INSTRUCTIONS
ACCUSPLIT, Inc.  •  3090 Independence Drive, Suite 148  •  Livermore, CA 94551
925-290-1900  •  800-935-1996  •  FAX 925-290-1930  •  www.ACCUSPLIT.com  •  [email protected]
ACCUSPLIT®
       EAGLE
™ 1120
Eat Right!  Walk More!  Live W\fll!  The A\b\bUSPLIT Lifestyle
Congratulations on taking the first step to wellness with your purchase of an  ACCUSPLIT pedometer. It’s easy to set up your new pedometer.  Just follow the steps below, and start walking!
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily. To reset:  
Press and hold RESET button for at least three seconds to  
reset to zero. 
AUTO MOVEMENT SENSOR
1. To filter out random movements, the unit remains in standby   
  mode until 5 continuous steps are registered. Only then are   
  the 5 steps calculated in, and an Active indicator “ ▲” 
  appears on the upper left of display.
2.  When regular walk/run movement stops, after 2 seconds the   
  timer pauses and the unit switches to standby status (Active   
  indicator “ ▲” disappears). 
REP\bACING THE BATTERY
When the display starts to dim or goes blank, it is time to 
replace the battery. Your pedometer uses one Type L1142 
(LR43) 1.5 volt battery. To replace:  
1.  Using a jeweler’s screwdriver, loosen small screw   
  on back of unit. Remove back of case.
2.  Slide the old battery gently out of its holder. Replace it with  
  a new battery. The battery’s positive (+) terminal should be   
  FACE UP while you put it into the pedometer.
3.  Gently press front and back of pedometer case back   
  together, being sure to line up slots and tabs at top and   
  bottom of unit.
4. Replace the screw snugly, but gently.
5. Perform a RESET function, pressing RESET button for  
  3 seconds.
ACCUSPLI T
AccuSTEP
1
0000 .org
STEP
TW
15MG
1 12 0
EAGLE
RESET
VIEWING YOUR RESU\bTS
Once you put on your pedometer, it will automatically begin to 
record your steps.  970-042vB
First, loop the 
pedometer clip
Ne\ft, loop the metal 
clip, then clasp clothin\Ng
\br, loop a  
badge holder, then   put into pocket
(Badge holder   
not incl\fded)\br, loop a belt or be\Nlt loop
N\b-PR\b\bF-\bF-PURCHASE LIMITED WARRANTYRefurbish, repair-or-replace service be\vfore \f0/\f/\f0, $\b fee; \vAfter \f0/\f/\f0, 
service may not be \vavailable. Return wi\vth fee and day pho\vne # to:  
AST Repair Center/970-\f0\f0, 2290M Ringwood\v Ave., San Jose, CA 9\v\b\f3\f
REGISTER NOW Please return 
your AE\f\f20 Registr\vation to the 
Repair Center addr\vess in the 
warranty, and we will let yo\vu 
know about future p\vroducts.  Email (preferred)
User