Accusplit Pedometer AE100XLE User Manual

							Key Features
•	 Built	around	the	Kato-designed	JW200	PedometerEngine™		
	 Step	Sensor,	the	current	gold	standard	for	accuracy.	
•	 The	ACCUSPLIT	exclusive	case	makes	this	the	slimmest		
	 available	pedometer	built	around	the	JW200	Step	Sensor.
•	 Chromed,	Spring	Steel	clip	resists	breakage.
•	 Case	includes	two	leash	slots,	for	attaching	safety	leash		
	 on	either	side.	Made	from	tough	polycarbonate	plastic.
For this special Educational series, the stride length (for AE140XLE and 
AE170XLE) and weight settings (for AE170XLE) are fixed. Therefore, 
students will all get the same amount of credit for distance walked (1.75 
ft stride, which is 3000 steps per mile) and calories burned (weight used 
is 100 lbs), and there is no special setup required! 
HOW TO OPEN YOUR PEDOMETER.
See	diagrams	at	right.
WEARING YOUR PEDOMETER
While	gently	holding	the	belt	clip	open,		
slide	the	pedometer	onto	your	belt		
or	the	top	edge	of	your	pants	or	skirt.		
It	should	fit	snugly	and	level,	above		
one	knee.
Note: The	pedometer	should	be	as		
vertical	as	possible.	 Walkers	with		
larger	stomachs	may	find	it	helpful		
to	wear	the	pedometer	farther	back		
on	the	body,	toward	one	hip.	
The cover must be closed for the pedometer to work. 
To	avoid	losing	or	dropping		
your	pedometer,	use	the		
included	leash	and	clip	to		
fasten	the	pedometer		
securely	to	your	clothing.
Attaching the Leash
1.	 Attach	the	pedometer	to		
	 the	leash	by	looping	the		
	 thin	side	of	the	leash		
	 through	the	one	of	the		
	 leash	slots	on	the		
	 pedometer	case.
2.	 Put	the	pedometer	onto		
	 your	clothing	as		
	 discussed	above.
3.	 Attach	the	alligator	clip	to	a	belt	loop	or	the	top	edge		
	 of	the	pants	or	skirt.	
Note: You	can	also	use	a	safety	pin	to	fasten	the	leash	to	your	clothing,	
loop	the	leash	through	your	belt	or	belt	loop,	or	use	a	badge	holder.
VIEWING YOUR  RESULTS
Once	you	put	on	your	pedometer	with	the	cover	closed,	it	will	
automatically	begin	to	record	your	steps,	activity	time,	distance	
(AE140XLE	and	 AE170XLE),	and	calories	(AE170XLE)	burned.	
Repeatedly	press	the	MODE	button	to	cycle	through	the	pedometer	
modes:
STEPS	g	 TIMER	g	STEPS	(AE120XLE)
STEPS	g	 TIMER	g	DISTANCE	g	STEPS	(AE140XLE)	
STEPS	g	 TIMER	g	DISTANCE	g	CALORIES	g	STEPS	(AE170XLE)
RESETTING YOUR  PEDOMETER
Most	people	prefer	to	reset	counts	daily.	 To	reset	your	counts:	From	
STEP,		 TIME,	DISTANCE	(AE140XLE	and	 AE170XLE),	or	CALORIE	
(AE170XLE)	mode,	press	and	hold	the	yellow	RESET	button	for	at	
least	2	seconds.	 You’ll	see	the	values	all	go	back	to	zero.	
REPLACING THE  BATTERY
When	the	display	starts	to	dim	or	goes	blank,		
it	is	time	to	replace	the	battery.	 Your	pedometer		
uses	one	 Type	LR44	1.5	volt	alkaline	battery.
To	replace:
1.	 Insert	a	coin	into	the	slot	on	the	bottom	of	the		
	 case,	and	twist	to	loosen	the	faceplate.	Remove		
	 faceplate	and	set	aside
2.	Locate	the	battery	holder	as	seen	on	sketch.	Pull	out	the	old		
	 battery,	and	push	a	new	LR-44	battery	into	the	holder,	with		
	 positive	terminal	(+)	facing	up.
3.	Snap	faceplate	back	into	place,	hooking	the	bottom	two	tabs	first, 		
	 then	closing	by	pressing	together	at	the	top	two	tabs.
4.	 Press	all	3	buttons	at	the	same	time	to	perform	a	Master	Reset		
	 to	assure	best	battery	life.	
SPECIFICATIONS, FEATURES, and FUNCTIONS
Description of Functions
•	 Counts	steps	up	to	99,999	then	rollover
•	 Counts	time	spent	in	step	activity,	up	to	999	Min	59	sec,	then 		
	 rollover.	 Automatically	counts	whenever	step	activity	is	occurring.
•	 Counts	distance	traveled	during	step	activity	(AE140XLE	and		
	 AE170XLE),	up	to	999.99	mi,	then	rollover.	 Automatically		
	 counts	whenever	step	activity	is	occurring.
•	 Counts	Calories	consumed	during	step	activity	(AE170XLE),	up		
	 to	9,999.9	Kcal,	then	rollover.	 Automatically	counts	whenever		
	 step	activity	is	occurring.
ACCUSPLIT, Inc.  •  7901 Stoneridge Drive, Suite 350  •  Pleasanton, CA 94588
800-935-1996  •  925-290-1900  •  FAX 925-290-1930  •   www.ACCUSPLIT.com   •  support@ACCUSPLIT .com
Congratulations	on	taking	the	first	step	to	wellness
		
with	your	purchase	of	an	ACCUSPLIT	pedometer. 		
It ’s	easy	to	use	your	new	pedometer,	with	nothing	to	set	up. 	
Just	follow	the	steps	below,	and	star t	walking!
AE120XLE, AE140XLE,  and AE170XLE
INSTRUCTIONS
ACCUSPLIT®
 EAGLE
™  
STEP   TIME     DIST    CALDIGI-WALKE RXL.COM
170XLEJW200
5638
REGULAR DISPLAY MODES
Press	the	yellow	MODE	button	to	cycle	through:	
•	 STEP:	STEP	mode	shows	step	count.
•		 TIME:	 AUTO	ACTIVITY	 TIMER	(AAT)	MODE	shows	total		
	 activity	time	in	min	and	sec.	
•	 DIST:	DISTANCE	mode	shows	distance	traveled	(mi).		
	 (AE140XLE	and	 AE170XLE)
•	 CAL:	CALORIE	mode	shows	calories	burned.	(AE170XLE)
ACCUS PLIT EAGLE
Digiw alkerX L.co mSTEP    TIME   DIS T   CAL4728MODE
RESET170XLE
yes
no
First, loop leash 
through slot on side 
of pedometer.
Next, clasp clothing
Or, loop a  
badge holder, then   put into pocket
(Badge	holder	 	
not	included)
Or, loop a belt   
or belt loop
REGISTER NOW Please return  
your AE100XLE pedometer registra-
tion to the Repair Center address 
in the warranty, and we will let you 
know about future products.  Email (preferred)
User
Battery
221-1608
Eat Right! Walk More! Live Well ! 
The ACCUSPLIT LifestyleNO-PROOF-OF-PURCHASE  LIMITED WARRANTYFree service for first year of ownership;  
$12 fee for service thereafter. See label inside unit for date.  
PROOF-OF-PURCHASE WARRANTYSave receipt for Proof-of-Purchase Warrant y, if purchase date yields bet ter  Dates of Ser vice than dates on the label’s No-Proof-of-Purchase Warrant y.
See www.ACCUSPLIT.com/support for details